Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Slide-Channel Door Closer Hydraulic
zhengfeng-CLEANROOM-SLIDE-CHANNEL-DOOR-CLOSER-HYDRAULIC

Cleanroom Slide-Channel Door Closer Hydraulic

A compact overhead guide rail returns the door under hydraulic control, with force and speed tuned to the installed leaf and seals.
  • Closing-force adjustment accommodates different leaf requirements.
  • Backcheck slows a forcefully opened door.
  • Guide-rail geometry limits projecting arm hardware.
Request a Quote Browse Products

Controlled return through an overhead guide rail

The hydraulic slide-channel closer returns a single-action door toward its closed position through a lever and guide rail. The rail keeps the operating linkage close to the door profile and avoids the projection of a conventional articulated arm. It is useful on cleanroom and laboratory doors where a compact overhead arrangement and adjustable closing behaviour are required.

A spring provides the closing torque while hydraulic controls regulate motion. Closing force, closing speed, final latching action and backcheck have different purposes. Increasing speed is not the same as increasing the available closing force, and backcheck acts during opening rather than holding the door shut.

Size for resistance as well as leaf width

The listed adjustable EN 2–6 force range and 1400 mm maximum-width reference describe a closer configuration. Selection also depends on mounting geometry, hinges, seals, latch resistance, door dimensions and pressure across the opening. They do not establish that every 1400 mm cleanroom door will close reliably or be easy to open.

Choose sufficient closing torque at the difficult part of travel while retaining acceptable manual opening effort. If the door rubs, a stronger setting usually masks the underlying fault. Correct alignment and seal interference before tuning the closer.

Installation and adjustment schedule

DecisionWhy it matters
Body and rail positionUse the correct hinge-side or opposite-side mounting template
Frame and leaf supportFix into reinforced structure rather than unsupported thin skins
Main closing speedAllow passage while returning the leaf without impact
Latching adjustmentOvercome the final resistance without excessive closing shock
BackcheckDampen forceful opening within the selected mechanism capability
Opening limitProvide a suitable stop or compatible restrictor where required

Backcheck should not be treated as a structural door stop. Check rail travel and clearances around the header, seals and neighbouring equipment. A mounting plate can solve a fastening or geometry issue only when it belongs to the approved installation arrangement.

Commission under operating conditions

Test closing from a wide opening and from near the latch with the ventilation system in its normal operating states. Record force and valve settings after the leaf closes and latches consistently. Follow the adjustment limits: excessive valve opening can cause leakage or loss of control.

Optional mechanical hold-open changes the self-closing behaviour and requires a compatible doorway application. A fire or smoke requirement needs evidence for the complete approved assembly, not just an EN force label. Inspect fixings, rail movement and oil leakage during service. Where final movement needs separate fine control, compare the soft-close guide-rail version.

Planning your Cleanroom Slide-Channel Door Closer Hydraulic specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us