Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Slide-Channel Door Closer Electric Free-Swing
zhengfeng-CLEANROOM-SLIDE-CHANNEL-DOOR-CLOSER-FREE-SWING

Cleanroom Slide-Channel Door Closer Electric Free-Swing

The leaf moves manually in free-swing mode, while a compatible electrical release restores the closer action when the system requires closure.
  • Free-swing operation eases repeated manual passage.
  • Release control restores the closing function when required.
  • Guide-rail mounting avoids a broad articulated arm.
Request a Quote Browse Products

Low-effort manual movement with a closing reserve

The electric free-swing guide-rail closer allows repeated manual door movement with reduced closer resistance after its free-swing state has been established. An electrical release restores the closing action. It is intended for openings where easy everyday passage and controlled closing on a defined release event are both required.

This is a manually moved door arrangement, not a powered opener. Free swing also differs from holding a leaf at one fixed angle. The selected unit determines the initial opening movement needed to set the function and the usable free-swing range.

Define when the door must return closed

A free-moving leaf can remain away from the frame during ordinary use. That operating mode needs particular attention at a cleanroom boundary where pressure separation or interlock permission depends on closure. Establish whether free swing is suitable at that opening and how the system will request closing before another door is released.

The closer does not create a room-pressure or door-locked signal. Use suitable independent feedback where those conditions form part of the control sequence. If closing on a fire or smoke signal is required, specify the complete compatible release system and its approval evidence for the installation.

Assembly and interface requirements

ItemSelection basis
Supply24 VDC reference configuration with compatible release control
Closing capacityAdjustable EN 3–6 reference, selected for the actual resistance
Leaf widthUp to 1400 mm reference, subject to mounting and door conditions
MovementManual single-leaf operation with electrically enabled free swing
MountingMatched overhead body, lever, guide rail and wiring route
System scopeRelease unit, detectors or inputs, manual release and monitoring as specified

Do not assume that the closer body includes all release controls, or that a generic access-control output provides the required supervision. Cable transfers must suit a moving leaf, and the mounting arrangement must retain access for adjustment. Backcheck or a comfort hold-open feature should only be included when supported by the selected version.

Test release from the positions users actually leave

Set up free swing using the prescribed procedure, then test closing after the intended release command and supply interruption. Repeat from several opening angles, including near closed, with normal ventilation resistance and latch load. Verify that restoration of power does not leave an unexplained operating state.

Record the release logic, reset procedure and maintenance test for the installed system. Check cable condition, fixings, rail motion and the return-to-closing function during service. A successful free-swing demonstration alone is incomplete acceptance; the door must also close and latch when the controlling system requires it.

Planning your Cleanroom Slide-Channel Door Closer Electric Free-Swing specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us