Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom Return-Air Riser Wall Panel 1180 mm Wide
zhengfeng-CLEANROOM-RETURN-AIR-RISER-WALL-PANEL-1180

Cleanroom Return-Air Riser Wall Panel 1180 mm Wide

A wider inlet helps only when the entire return route is appropriately sized.
  • The wider face accommodates a broader return inlet.
  • Site splicing follows modular panel installation.
  • Smooth surrounding face aligns with adjacent partitions.
Request a Quote Browse Products

Use the wider face without overlooking the outlet

The 1180 mm module integrates a return-air passage into a nominal 100 mm wall. Its wider face can accommodate a broader low-level collection opening in a larger airlock or cleanroom. The useful inlet area depends on the chosen grille and framing; module width alone does not establish airflow capacity.

A broad inlet may lower face velocity at a given flow, but it cannot remove a restriction at the top of the riser. The transition into the ceiling duct, internal braces and balancing device all affect pressure loss. Assess the entire route from the room to the return duct rather than choosing a panel from an unqualified volume range.

Coordinate the wide bay with pressure control

Reference constructionPlanning requirement
1180 mm module, 100 mm depthShow actual clear inlet and channel dimensions on the section drawing.
0.6 mm internal keelCheck framing, face support and permitted height for the installation.
Prefabricated metal facesMatch the surrounding partition finish and define sealed site connections.
Adjustable volume arrangementLocate the balancing component where it remains accessible after fit-out.

Airlocks often operate with a controlled supply and return imbalance. Altering this return setting can change room pressure and flow through door gaps. Balance the connected system and assess the relevant door states. A wider panel does not automatically produce more even room airflow or guarantee the pressure cascade.

Preserve access across the full inlet

Plan the grille position around furniture, cart parking and cleaning equipment. Provide removable access sized for the actual inspection task, with a repeatable seal on reinstatement. The internal return cavity should not also become an unplanned utility chase or a connection between pressure zones.

The enquiry should include return duty, pressure available, noise requirements and a top-connection drawing. Quote the inlet grille, panel body, transition, damper, access and perimeter seals with defined trade responsibilities. Acceptance should inspect internal cleanliness and closures before connection, then record airflow, balancing positions and room pressure after the complete ventilation system is operating.

Planning your Cleanroom Return-Air Riser Wall Panel 1180 mm Wide specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us