Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom High-Speed Roll-Up Door Integrated-Motor Compact Rapid-Roll
zhengfeng-CLEANROOM-HIGH-SPEED-ROLL-UP-DOOR-INTEGRATED-MOTOR

Cleanroom High-Speed Roll-Up Door Integrated-Motor Compact Rapid-Roll

A compact header houses the drive above a PVC curtain with a soft bottom and a recoverable edge-retention system.
  • An integrated motor reduces external drive projection.
  • Smooth composite covers conceal the structural steel.
  • A flexible lower beam replaces a rigid bottom crossbar.
Request a Quote Browse Products

A compact header with a recoverable flexible curtain

The integrated motor of this indoor rapid-roll door reduces the external drive projection beside the opening. Its galvanized steel structure is concealed by silver-gray reinforced-composite column and drum-side covers, with a black composite drum cover. This arrangement can suit constrained service corridors, but the compact operating footprint still needs space for motor removal and cover access.

What the curtain specification means

A single 900 g/m² PVC fabric sheet winds onto a steel drum and closes with a flexible ballasted bottom. The figure is mass per unit area, not thickness, thermal resistance or a fire classification. The reference maximum opening is 4000 × 4000 mm; the selected curtain, drum, drive and pressure conditions must be checked for the actual size. Optional windows or a full-width vision panel change the curtain assembly and should be included in its specification.

Retaining edges guide the fabric and can release during a breakaway event. The recovery cycle returns intact edges into the guides. It does not repair a torn curtain, bent guide or damaged sensor. After contact, inspect the opening and follow the specified recovery sequence before resuming traffic. A soft bottom reduces rigidity at the contact edge but does not replace obstruction detection.

Installation and operation

Set the columns parallel and the drum level on a structurally suitable opening. Unequal guides or an obstructed bottom path can create repeated breakaways that appear to be a control fault. Keep vehicle protection separate from the door frame so an impact does not transfer directly into the guides. Activation placement should account for approach speed and opening time without triggering unnecessarily from cross-traffic.

Clean PVC and composite covers using compatible agents. Check edge wear, the bottom beam and sensor alignment as part of routine service. Preserve electrical and motor service access when nearby pipes or cabinets are installed.

Quotation and handover

Include curtain and vision layout, header envelope, activation, protective sensors, controller, supply connection and commissioning. Record the selected operating speed and failure response rather than assuming a universal high-speed setting. Demonstrate normal cycles, presence protection, intact-curtain recovery and power-loss procedures. Any air-leakage or particle-emission target needs evidence for the selected assembly and installation.

Planning your Cleanroom High-Speed Roll-Up Door Integrated-Motor Compact Rapid-Roll specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us