Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Air Ducts & Air Distribution / Cleanroom HEPA Terminal Housing 305 x 305 mm
zhengfeng-CLEANROOM-HEPA-TERMINAL-HOUSING-305X305

Cleanroom HEPA Terminal Housing 305 x 305 mm

A welded 305 mm square filter housing with room-side retainers; element depth, sealing geometry and ceiling support define the selected assembly.
  • Compact frame suits individual ceiling filtration points.
  • Retainers support the element during room-side replacement.
Request a Quote Browse Products

A small terminal point with a separately selected filter

This welded ceiling housing holds a replaceable 305 x 305 mm filter at the final supply point. It suits a small individual terminal where the ceiling layout cannot accommodate a larger module. The housing positions the filter and closes the path around its frame; particle removal comes from the selected element. A compact case alone does not establish airflow capacity, HEPA efficiency or a room cleanliness class.

Fit the seal and filter depth before the ceiling opening

Catalog itemSelection meaning
Filter face305 x 305 mm; filter depth and frame profile must also match.
External frame392 x 392 mm reference size; this is not a ceiling cut-out dimension.
HousingWelded construction, with room-side element replacement.
Seal choicesFlat/DIN-type, PU gasket or gel interface, as specified for the chosen filter and casing.
RetentionTool-free clamping and pre-positioning supports in the listed arrangement.
Air entry and faceTop or side entry; optional perforated diffuser.

The seal choices require different mating details. A compressible gasket seats against a suitable contact surface; a gel-seal element needs the corresponding sealing blade and engagement geometry. The word DIN is not a complete seal specification. Select the exact profile, element depth and clamping travel together rather than assuming all 305 mm filters interchange.

Airflow and ceiling coordination

At a given volume flow, a smaller filter face carries more air per unit face area than a larger one. Select from the actual filter pressure-drop curve and terminal acoustic data, allowing for the system's available pressure as the filter loads. Excessive throttling at a small inlet can add noise; a larger terminal or revised branch may be preferable when the duty exceeds the selected assembly's data.

Show the neck dimensions, inlet orientation, casing depth, suspension points and access zone on the installation drawing. False-ceiling, suspended and T-grid installations require the corresponding mounting detail. Duct weight must not distort the sealing seat. Below-ceiling access must allow the face to open and the filter to pass out without contacting nearby equipment.

Service, quotation and acceptance

Keep the sealing seat clean, handle a replacement element by its frame and check the retainers before releasing its weight. The supports aid positioning; they do not justify an unspecified one-person lifting procedure. Filter replacement is based on condition and the facility's maintenance limits, while housing replacement is normally driven by damage or an interface change.

Specify whether the quote includes the element, diffuser, inlet damper, suspension hardware, pressure taps and aerosol test access. Acceptance should cover dimensions, secure retention, measured airflow and the agreed installed-filter leakage test. Pressure-drop readings are useful for monitoring but do not establish that the seal is intact. Record the filter identification and initial pressure reading for later service comparisons.

Planning your Cleanroom HEPA Terminal Housing 305 x 305 mm specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us