Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Air Ducts & Air Distribution / Cleanroom HEPA Terminal Housing 1220 x 610 mm
zhengfeng-CLEANROOM-HEPA-TERMINAL-HOUSING-1220X610

Cleanroom HEPA Terminal Housing 1220 x 610 mm

An elongated welded casing for a 1220 x 610 mm filter, with room-side support and access coordinated for the complete replacement operation.
  • Rectangular frame accommodates a broad replaceable filter.
  • Retaining hardware supports handling along the long opening.
Request a Quote Browse Products

A broad filter element needs a coordinated handling space

This elongated welded housing accommodates a nominal 1220 x 610 mm filter and allows replacement from the room below. Its broad face can suit a long supply position in a controlled-production ceiling. It is particularly useful when the desired terminal arrangement follows a rectangular equipment or ceiling zone, provided the filter can be removed safely in that location.

The permanent case locates the sealing interface while pre-positioning supports help hold the element before final clamping. Support during fitting does not remove the need to assess filter mass, reach and a lifting method. A long element must be supported by its frame without twisting the frame or touching the filter media.

Reference geometry and build choices

ParameterCatalog reference
Filter format1220 x 610 mm; specify depth and exact frame construction separately.
External frameApproximately 1307 x 687 mm; verify the unequal border dimensions on the fabrication drawing.
BodyFully welded housing.
EntryTop or side; rectangular side-inlet option.
SealDIN-type flat, PU gasket or gel interface, matched to the element.
Access/retentionHinged room-side face, pre-positioning supports and tool-free retainers.
Face optionsPerforated or four-way configuration.

Long casing, inlet position and air distribution

The published frame dimension is a reference, not an instruction to cut the ceiling. A long opening needs coordinated suspension locations, ceiling support and a straight sealing plane. Carry duct loads separately so a side connection does not pull the case out of alignment. Allow the hinged face its complete opening arc and a clear route for removing the element.

Top and side entry solve different duct-routing problems. In a long plenum, inlet location and the distance to the filter affect how the supply reaches the face. Require the selected assembly's flow and resistance data rather than multiplying the capacity of a small square unit by area. If the process depends on uniform downward air, include the relevant velocity mapping and airflow visualization in the design acceptance plan.

Replacement, evidence and quotation scope

Before fitting a replacement, inspect the entire long seal path and confirm that every retaining point engages as intended. Local damage or uneven seating can create a bypass even when the media is undamaged. After replacement, restore the diffuser and follow the facility's testing and room-release procedure; pressure drop alone cannot locate a seal leak.

Request a quote against the actual element dimensions, mass, seal geometry, inlet and ceiling drawing. Identify whether filters, face panels, support hardware, damper, test ports and commissioning are included. Acceptance should verify dimensional fit, service access, secure clamping, required flow and installed leakage. The housing format makes no independent promise of room classification, containment or a particular filtration efficiency.

Planning your Cleanroom HEPA Terminal Housing 1220 x 610 mm specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us