Cleanroom Floor-Spring Door 2000 mm Double HPL
- The broad paired opening serves trolley-oriented circulation.
- Separate floor-spring control supports each pivoted leaf.
- HPL faces maintain a consistent laminate appearance across the entrance.
Two pivoted leaves for a wide circulation route
This double HPL door is arranged around a 2000 × 2100 mm wall hole. Each leaf has floor-spring control and top and bottom pivot support, with rubber gasketing and stainless handles. It suits trolley circulation where a single narrow leaf would make passage awkward and the floor can accommodate two closer positions.
Design the pair as one moving assembly
The two floor devices act separately, but their pivot positions and return settings determine what happens at the center. Specify leaf geometry, swing direction, stops and meeting-edge clearances together. If the meeting detail requires one leaf to close first, use a compatible coordination arrangement; two independent closers do not automatically provide it.
The 2000 mm wall opening does not equal clear passage. Assess the opening with the leaves at their intended working angles and allow space around the handles. Normal traffic may use one leaf, while a large trolley needs both. A trial with the representative load helps establish whether independent manual operation is practical for that route.
Plan both floor pockets and the shared frame
Set the device locations from the same finished floor datum and match each lower pivot to its upper support. Unequal floor levels or a twisted frame can produce different clearances and an uneven meeting line. Keep both access covers removable, with compatible moisture protection around the closer housings and floor finish.
Choose closer duty from each complete leaf's mass and width, along with seals and room pressure. Higher force increases user effort; correcting rubbing or an incorrect pivot axis comes before adjusting force. The HPL faces need a cleaning method compatible with their bonded edges and hardware penetrations.
Buying and accepting the complete pair
The supply scope should identify both closer sets, pivots, boxes and covers, frame interface, HPL construction, gaskets, handles and any closure coordination. Handover includes separate and combined leaf operation, actual trolley clearance, return behavior and accessible floor covers. Keep debris out of the meeting area and inspect loose pivots or damaged edges promptly. A wide paired entrance with rubber seals does not by itself establish airtight or fire-rated performance.
Planning your Cleanroom Floor-Spring Door 2000 mm Double HPL specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.