Cleanroom Equipment Access Door 1800 mm Stainless Reinforced
- The wide pair accommodates larger equipment envelopes.
- Stainless faces give a different cleaning surface from coated-steel alternatives.
- A common reinforced frame keeps both leaves within one coordinated opening.
A broad stainless-faced equipment entrance
This reinforced double door provides a 1800 × 2100 mm wall hole with 40 mm stainless-faced leaves. The frame is intended for either a 50 or 90 mm wall configuration. It is suited to larger transfer routes where the doorway and its adjoining circulation space can accommodate the equipment and the swinging leaves.
Width is only one transfer constraint
The 1800 mm dimension describes the wall hole. Clear passage is smaller after the frame, door stops and open leaves are included. The 2100 mm wall-hole height also leaves less finished clearance, so overhead fittings or tall equipment can remain the limiting factor. Check the complete route, turning space and equipment transport position before relying on the wider opening.
Define the leaf split and normal operating leaf on the shop drawing. If both leaves need holding clear during a transfer, the holding method must be compatible with the selected door function. Do not remove fixed frame members or use the frame as a lifting point to gain extra clearance.
Match support and finish to the duty
Wider leaves impose loads through hinges, frame reinforcements and anchors into the wall structure. Room pressure also affects the force needed to open and return them. The selected partition therefore needs suitable backing at the attachment locations; the designation 50 or 90 mm identifies the wall interface, not its load capacity.
Specify stainless grade and finish for the faces, plus the materials of the frame and hardware. Stainless handles can be selected, but do not establish an all-stainless assembly. Cleaning residues held at joints and fasteners can cause localized attack, so joint accessibility and the cleaning procedure matter as well as the alloy.
Commission the whole pair
The quotation should include leaf geometry, reinforced frame, wall supports, locks and secondary-leaf retention, optional upper closers, seals and installation finishing. Test the representative load through the finished opening and check closure order, latch engagement and manual effort with ventilation operating. Maintain hinges and retainers to their instructions, inspect stainless joints after cleaning, and investigate movement or distortion after any trolley impact before readjusting the closer.
Planning your Cleanroom Equipment Access Door 1800 mm Stainless Reinforced specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.