Cleanroom Emergency Exit Door 950 mm HPL Panic-Bar
- Defined door-hole size helps coordinate modular wall openings.
- Laminate facing gives a practical alternative to an all-metal leaf.
- Surface-accessible closing hardware simplifies adjustment.
An HPL exit coordinated to a defined wall opening
This single-leaf panic-exit doorset is planned around a 950 × 2100 mm wall hole. The HPL-faced leaf provides a nonmetallic finish for staff circulation, with frame and edge profiles protecting its perimeter. A push-type panic bar operates the escape-side release and an exposed upper closer returns the door after passage.
The 950 mm hole is not the clear exit width
The frame, open leaf, hinges and projecting hardware reduce the usable passage relative to the wall hole. Establish finished clear width and height from the chosen doorset drawing and opening angle before accepting it for the route. If the resulting passage is insufficient, the solution may require a larger opening rather than a different bar fitted to the same narrow leaf.
Frame options suit 50 or 100 mm panel walls. These dimensions describe the compatible wall system and do not establish the door leaf thickness. The opening needs suitable reinforcement for the hinge loads and closer reactions. Fastenings for the panic device require internal backing; HPL and thin facings alone are not a structural fixing detail.
Hardware, finish and daily operation
Select the entry-side handle or cylinder so it controls entry while preserving the required panic release. The bar, lock and strikes must be compatible with the leaf dimensions and handing. Any electronic access interface should have a defined failure response for the escape route.
Balance closer adjustment with seals and room pressure. A stronger closer can improve latching yet increase opening effort. Check both functions with the ventilation system operating. The exposed closer is accessible for service, but its arm needs clearance from the wall and overhead services throughout the swing. Clean HPL, edges and hardware with compatible products and repair damaged joints before moisture reaches the substrate.
Quotation and acceptance
State the wall-hole size, required finished passage, actual panel thickness, swing direction, HPL finish and hardware combination. Include reinforcement, frame, panic device, outside trim, closer and installation. Handover should measure the usable opening and demonstrate panic release, complete reclosure and latching. Record any required doorset or hardware certification for the supplied configuration; HPL facing and a push bar alone do not establish fire or exit compliance.
Planning your Cleanroom Emergency Exit Door 950 mm HPL Panic-Bar specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.