Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Door Position Sensor Surface-Mounted Magnetic
zhengfeng-CLEANROOM-DOOR-POSITION-SENSOR-SURFACE-MAGNETIC

Cleanroom Door Position Sensor Surface-Mounted Magnetic

A surface-mounted reed contact and matched magnet for leaf-position feedback, installed with alignment margin and a defined controller truth table.
  • Retrofit Surface Contact Pair
  • Defined Open and Closed States
  • Installed Sensing-Margin Checks
Request a Quote Browse Products

Door position feedback for a retrofit installation

This two-piece surface contact places a magnetic reed switch on the fixed frame and a matching magnet on the moving leaf, or in the permitted equivalent arrangement. Movement changes the magnetic field at the switch and therefore the electrical contact state. It is useful where a recessed sensor would interfere with the door construction or where accessible surface wiring is preferred.

The output indicates whether the magnet is within the switching zone. It does not prove that a bolt is engaged, a seal is compressed or the room pressure has recovered. An interlock that needs those conditions must use the corresponding feedback rather than treating one door contact as proof of all three.

Define the contact states and electrical limits

Terms such as normally open can refer to the reed without its actuating magnet, while the access controller may describe the normal condition as door closed. Provide a simple state schedule showing continuity with the door open, closed and with the cable disconnected. Set the controller input from that schedule.

Selection itemMeaning for installation
Matched switch and magnetUse the supplied pair and specified orientation rather than an arbitrary replacement magnet
19 mm gap referencePreliminary catalogue reference only; the installed working gap needs margin inside the verified sensing zone
Contact loadingObserve maximum switching voltage, current and power together, plus any load restrictions
Controller connectionUse a suitable low-energy sensing input with the agreed monitoring arrangement
Mechanical mountingCoordinate spacers, protected cable routing and a stable fixing surface

A voltage limit and a current limit are not permission to apply both maxima simultaneously. The allowable switched power and load type can impose a lower limit. This position contact should not be treated as a lock-power relay.

Establish a dependable sensing margin

The point where a reed changes state as the magnet approaches can differ from the point where it changes state as the magnet withdraws. Evaluate both directions on the installed door. Steel frames, mounting orientation and nearby magnetic hardware can alter the result, so a catalogue maximum is not the target setting.

Align the parts with allowance for normal hinge movement, seal compression and door rebound. Make the cable exit cleanable and protect it from being pulled during maintenance. Avoid locating a projecting sensor where carts or cleaning equipment can strike it.

Commissioning and fault finding

Observe the controller indication while slowly closing, opening and lightly moving the latched leaf. Confirm that a small movement near the threshold does not produce repeated state changes. Test the agreed open-circuit and short-circuit faults where the controller supports line supervision; a simple two-wire contact alone cannot distinguish every cable fault from a valid state. End-of-line components must match the input design.

If an interlock reports intermittent closure, inspect alignment and hinge condition before extending an input delay. Filtering may suppress brief bounce but cannot restore a missing sensing margin. Recheck after door adjustment, magnet replacement or work on nearby locks, and keep the sensing faces free of accumulated deposits.

Planning your Cleanroom Door Position Sensor Surface-Mounted Magnetic specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us