Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Cleanroom Door Position Sensor Recessed Biased High-Security
zhengfeng-CLEANROOM-DOOR-POSITION-SENSOR-RECESSED-BIASED

Cleanroom Door Position Sensor Recessed Biased High-Security

A concealed magnetic contact with a matched biased arrangement and a separate supervisory path for prepared door and frame recesses.
  • Prepared Recessed Mounting
  • Matched Biased Magnetic Pair
  • Separate Tamper-Loop Coordination
Request a Quote Browse Products

Concealed sensing with a matched magnetic arrangement

This recessed sensor places cylindrical switch and magnet components within prepared openings in the leaf and frame. Magnetic biasing makes operation depend on a more specific field arrangement than a basic unbiassed reed contact. It is intended for a doorway where discreet hardware and a supervised monitoring connection are useful, provided the door construction permits the required preparation.

Biasing does not establish an independently verified security grade or resistance to every magnetic interference attempt. Use the matching actuator and orientation, and require application-specific evidence if a security specification demands a particular classification. The device remains a door-position sensor rather than a lock-engagement detector.

Prepare the door without losing alignment or service access

Planning referenceHow to use it
19 mm bore diameterOriginal nominal reference; drilling depth, fit and flange seating require the selected installation drawing
10 mm maximum gapOriginal preliminary reference, not the target operating clearance or a verified site limit
Opposed sensing facesCoordinate orientation and alignment through the expected leaf movement
Concealed cableProvide a protected route and a recoverable connection for future replacement
Tamper loopDefine exactly which condition the supplied loop detects and how the panel interprets it

Check the frame material and reinforcement before drilling. Steel around a sensor changes the magnetic environment, and a recess placed near a latch pocket or door reinforcement may be impractical. Preparation of a fire-rated or otherwise assessed door must remain within its permitted construction details.

Do not force the housing into an undersized bore or trap its cable against a sharp edge. Seal exposed core and cable penetrations in a way that preserves the cleanroom wall or door requirements while allowing removal of the sensor. A hidden joint that cannot be reached makes a minor sensor replacement unnecessarily disruptive.

Supervision needs a defined circuit

A separate tamper loop can support an additional monitored path, but a simple wire loop does not automatically detect opening the sensor body or a short across its conductors. Determine whether the supplied unit has a physical tamper switch, a cable loop or another arrangement. Match any end-of-line components and input thresholds to the controller.

Document the contact state with the magnet present and absent, plus the expected fault indications. Do not infer the controller logic from a normally-open or normally-closed label without defining the reference condition.

Acceptance and upkeep

Test closure and opening at the finished door, including modest movement from hinges and seals. Establish reliable changeover with margin rather than setting the gap at a published maximum. Verify door position and tamper indications separately, then demonstrate the fault conditions actually supported by the circuit.

Repeated nuisance alarms should prompt checks of leaf sag, seating depth and magnetic alignment before changing controller delays. After hinge adjustment or sensor replacement, repeat the functional checks. Retain a record of the matched parts and mounting orientation so maintenance does not substitute a visually similar magnet with a different field.

Planning your Cleanroom Door Position Sensor Recessed Biased High-Security specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us