Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom Cove Base Skirting R60 Standard Aluminum
zhengfeng-CLEANROOM-COVE-BASE-SKIRTING-R60-STANDARD

Cleanroom Cove Base Skirting R60 Standard Aluminum

An exposed metal R60 floor cove with separately detailed supports and perimeter seals.
  • The metal face remains the exposed cleaning surface.
  • A 60 mm radius rounds the floor junction.
  • Separate floor and curved components form a coordinated base assembly.
Request a Quote Browse Products

An exposed metal transition at the wall base

The R60 cove-base arrangement uses a floor profile, concealed support and curved aluminum connector to finish the cleanroom wall-to-floor junction. The metal face remains exposed, so its surface treatment and edge seals become part of the routine cleaning surface rather than being covered by resilient flooring.

Coordinate the complete base section

The nominal cove radius is 60 mm. The 33.5 × 24 mm floor-profile reference describes a component of the assembly, not the finished upstand height or total projection. The section drawing must place the floor finish, wall panel, carrier and sealant edges on a common finished-floor datum.

6060-T6 aluminum is the proposed support material, with naturally anodized or painted exposed finishes. The alloy and temper identify the metal specification; they do not establish resistance to every detergent or disinfectant. Select the finish and sealing materials for actual chemical concentration, contact time and cleaning temperature.

Fixing and wet-cleaning interfaces

Attach the base and carrier to the intended support without forcing the curve against an uneven wall. The transition has distinct wall-side and floor-side interfaces, both of which need the specified sealing detail. Fixing the metal components together does not close those interfaces automatically.

Resolve corners, door ends and run joints before installing straight lengths. Where the floor and partition move differently, provide a joint capable of accommodating that movement. Avoid trapping cleaning water behind an unsealed lower edge. A metal cove is not an impact rail or a substitute for the floor waterproofing design.

Quotation and acceptance

Provide the floor build-up, panel base section, room perimeter, corner schedule and cleaning regime. Quote the floor profile, supports, exposed cove, corner fittings, finish and seals separately. Acceptance should check radius continuity, stable engagement, smooth terminations and complete edge seals against a sample junction. Inspect the lower seal, coating and any impact dents during service; repair the underlying attachment if movement causes repeated seal failure.

Planning your Cleanroom Cove Base Skirting R60 Standard Aluminum specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us