Cleanroom Ceiling Air Diffuser 600 x 600 mm Square Cone
- Full modular face integrates into a standard square ceiling bay.
- Removable cone core supports room-side access.
A modular face for a square ceiling bay
The nominal 600 x 600 mm diffuser provides a broad square face for T-bar ceiling layouts, with a removable formed-metal cone core and circular inlet behind it. Its purpose is to distribute comfort supply air around the ceiling and mix it into the room. The module size coordinates appearance and installation; it does not mean that the full square face is open area or that airflow capacity is fixed.
Coordinate the ceiling module and neck independently
| Item | Listed specification |
|---|---|
| Face module | 600 x 600 mm nominal. |
| Ceiling opening | 549 x 549 mm catalog reference; use the selected border drawing for installation. |
| Discharge | Four-way horizontal cone arrangement. |
| Surface/core | White-coated formed metal; removable core. |
| Mount | T-bar lay-in construction. |
| Inlet | Circular neck, with diameter selected for the duty. |
| Options | Insulated backpan or fourth-cone arrangement. |
Nominal module size, actual panel edge size and available bearing on the T-bar are different dimensions. Check the grid detail and any retaining clips or independent support required by the ceiling design. Do not force a panel into a grid or use the face to support branch ductwork.
Choosing capacity and the cone arrangement
Several inlet sizes can serve a similar-looking ceiling face. Selection therefore starts with required flow and acceptable sound, followed by pressure loss and throw under the intended supply temperature conditions. A large panel is not evidence of low sound if a small neck is carrying a high volume.
The optional fourth cone changes the discharge geometry and available passages; it should be supplied with performance data for that construction. It is not automatically an upgrade in flow or efficiency. Check reduced-flow operation as well as design flow, especially where cool air must stay near the ceiling before mixing into the occupied zone.
Installation and service details that affect performance
The removable centre provides access to the inlet area, but the chosen damper and adjustment method must remain reachable. Inlet bends or compressed flexible duct can cause asymmetric flow. Keep the connection supported, and ensure that the core is fully retained after balancing or cleaning.
An insulated backpan can form part of the condensation-control detail. Continuity of insulation and vapour sealing at the neck and duct joint matters as much as the panel option. Inspect damaged coatings, deposits and loose parts during cleaning, and restore the original cone orientation.
Order and acceptance information
State the ceiling grid, actual border, neck size, airflow range, fourth-cone choice, finish and insulation scope in the inquiry. Include balancing hardware and installation accessories as separate quotation items when needed. At handover, measure volume with the appropriate correction or method for the selected diffuser and check retention, sound and occupied-zone distribution. This mixing diffuser provides no filtration rating or cleanroom classification on its own.
Planning your Cleanroom Ceiling Air Diffuser 600 x 600 mm Square Cone specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.