Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom Aluminum Extrusion Profile 28 x 14 mm Hidden-System
zhengfeng-CLEANROOM-ALUMINUM-PROFILE-P28X14-HIDDEN

Cleanroom Aluminum Extrusion Profile 28 x 14 mm Hidden-System

A concealed assembly member with defined mating geometry and access before joint closure.
  • A small section envelope preserves space inside the joint.
  • The profile is intended for concealed-system use.
  • The dedicated section avoids substituting a corner angle for a different interface.
Request a Quote Browse Products

A concealed member within the wall assembly

The 28 × 14 mm profile is intended for an internal cleanroom wall interface. It coordinates the hidden connection while a separate surface component provides the visible finish. This distinction is useful when planning the assembly sequence: the concealed member may need to be installed and inspected before panels or cover trims close the joint.

Match the working geometry

The nominal 28 mm width and 14 mm height define an envelope, not the full mating detail. Establish the engagement surfaces, fastening locations, section thickness and clearance to the panel core. A generic corner angle or a visually similar extrusion may obstruct the cover or fail to retain the connected part.

6063 aluminum in T5 or T6 temper is an available specification route. Select the material together with the attachment and any required pull-out or bending assessment. Concealed placement does not establish structural capacity or remove the need to consider corrosion at dissimilar-metal contacts.

Coating, closure and future access

Anodized or powder-coated surfaces can be specified, with proposed film ranges of 8–25 µm or 40–120 µm respectively. Choose a defined coating system rather than treating the whole range as one finish. Where two components engage closely, verify the fit after finishing because coating builds up on the mating surfaces.

Set the member against an aligned support, remove machining debris and inspect the hidden fasteners before closure. Locate the enclosure air seal explicitly; hiding a metal connection does not seal it. If the wall must be dismantled later, document the release sequence and which cover or seal must be replaced. Do not bury a serviceable connection behind an irreversible finish without considering access.

Order and acceptance requirements

Submit the assembly section, companion-part references, run lengths and installation sequence. Stock-length proposals in the 3000–6000 mm range and shorter cuts should be coordinated with handling and joint locations. Quote extrusion, finish, machining, fasteners and visible covers separately. Accept by section inspection, finished-part trial assembly and recorded checks of hidden connections before the joint is closed.

Planning your Cleanroom Aluminum Extrusion Profile 28 x 14 mm Hidden-System specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us