Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Cleanroom Aluminum Extrusion Profile 30 x 9 mm Omega
zhengfeng-CLEANROOM-ALUMINUM-PROFILE-OMEGA30X9

Cleanroom Aluminum Extrusion Profile 30 x 9 mm Omega

A shallow raised Omega interface specified by its mating section and finished dimensions.
  • The Omega cross-section provides a shallow raised centre.
  • Continuous extrusion keeps the mating geometry consistent.
  • A compact depth suits closely spaced panel interfaces.
Request a Quote Browse Products

A shallow raised interface along the panel joint

The 30 × 9 mm Omega extrusion combines a raised centre with outward flanges. It can form a continuous interface where a flat strip would sit at the wrong level or fail to reproduce the required mating shape. Its suitability depends on the adjoining section and fastening detail, rather than the Omega name alone.

Specify the cross-section at its working surfaces

The nominal envelope is 30 mm wide by 9 mm deep. A useful drawing also identifies metal thickness, flange width, internal radii and any screw or clip seating surfaces. Two profiles with the same overall dimensions can have different internal clearances and cannot be assumed to interchange.

6063 aluminum with T5 or T6 temper can be discussed for the extrusion. Temper affects mechanical properties, while section geometry and support spacing govern how the installed strip responds to load. A change of temper does not compensate for an incorrectly fitted flange.

Finish and installation trade-offs

Anodized and powder-coated finishes are options. The proposed film ranges of 8–25 µm and 40–120 µm respectively are finish-selection ranges, not proof of chemical resistance. Specify the chosen system and finished dimensions: coating on opposing mating faces reduces available clearance.

Seat the flanges on an even support and locate fasteners so tightening does not crush or twist the raised centre. Plan cut ends, corners and sealant interfaces before installation. An extrusion is not an air seal by itself; exposed joints need the sealing detail required by the enclosure. Remove swarf and burrs before closing adjacent panels.

Purchase and acceptance scope

Supply the mating-section drawing, total run, corner details and cleaning agents. Lengths in the 3000–6000 mm range or shorter cuts can be evaluated against transport, handling and joint positions. The quotation should distinguish extrusion, finishing, machining, connectors and end closures. Accept against the approved section, straightness and cut tolerances, finish sample and a trial fit of the actual mating parts. Inspect exposed coating and joint seals during routine cleaning.

Planning your Cleanroom Aluminum Extrusion Profile 30 x 9 mm Omega specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us