Cleanroom Aluminum Extrusion Profile 45 x 35 mm F-Section
- The F outline places both arms on one side of the stem.
- A 45 x 35 mm envelope for a separately specified receiver gap.
- A continuous section for alignment along the panel edge.
An asymmetric return for a panel edge
The 45 × 35 mm F-section places two projecting arms on one side of a main stem. This arrangement can receive or overlap a panel edge while leaving the other side of the stem clear. It is useful where a symmetric H-section would intrude into an adjacent surface or service space.
Fit depends on the gap between the arms
The 45 mm and 35 mm dimensions describe the overall section envelope. They do not identify the panel thickness that will fit. Specify the clear arm spacing, insertion depth, wall thickness and inside radii, including the space needed for any gasket, adhesive or sealant.
Orientation also matters. Reversing the section changes the visible overlap and the side available for fixing. A panel may need to slide into a continuous receiver before the adjacent wall is closed. If later room-side replacement is required, show how the panel can be released rather than assuming the F-shaped interface is demountable.
Support and cleanable termination
Fix the main stem to the designed support. The projecting arms locate the edge but should not be assigned an unsupported structural load merely because the extrusion appears substantial. Use packing or a corrected substrate where necessary to avoid distorting the profile with screws.
Choose the aluminum alloy, temper and finish for the actual connection and cleaning regime. Protect cut edges, remove burrs and prevent exposed ledges or unsealed pockets at terminations. A tight metal-to-panel fit is not a substitute for the specified air-sealing joint. During service, check the arm edges for distortion and the seals for separation caused by panel movement.
Information for quotation and handover
Provide a marked cross-section showing the room face, panel build-up, fixing substrate, cut lengths and corner arrangement. Identify finishing, drilled holes, end treatment and companion seals as separate supply items. Acceptance should include a trial fit with the finished panel, dimensional checks of the receiver gap, alignment and an inspection of the completed perimeter seal. No load rating follows from the 45 × 35 mm envelope alone.
Planning your Cleanroom Aluminum Extrusion Profile 45 x 35 mm F-Section specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.