Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Air Ducts & Air Distribution / Cleanroom Air Distribution Plenum Box 600 mm High-Capacity Diffuser with DN315 Spigot
zhengfeng-CLEANROOM-AIR-DISTRIBUTION-PLENUM-600-DN315

Cleanroom Air Distribution Plenum Box 600 mm High-Capacity Diffuser with DN315 Spigot

select actual airflow duty, complete assembly weight, suspension, insulation and service access.
  • DN315 connection selected for the actual terminal duty
  • Deep chamber accommodates equalisation above a broad face.
Request a Quote Browse Products

A deep chamber for a broad ceiling diffuser

This plenum connects a DN315 branch to a nominal 600 mm diffuser assembly. A broad chamber and internal equalising element redistribute the side-entry jet before air reaches the face. The High-Capacity designation identifies a large format; actual capacity depends on the selected diffuser, pressure and sound limits.

Plan the full overhead installation

Reference casing dimensions are 567 × 567 mm with a 410 mm height and a 313 mm outside spigot for the nominal DN315 connection. These do not define a universal 600 mm ceiling interface. Confirm the selected face, mounting geometry, insulation and connection envelope on the complete drawing.

Use the actual weight of the supplied box, diffuser, lining and accessories for suspension design. A mass from another diffuser-and-box combination is not a reliable support load. Allow a route for installing the deep chamber before the ceiling closes, plus access for subsequent inspection and component replacement.

Select airflow without creating a noisy restriction

Selection issueConsequence
Inlet transition and approachA nearby bend or abrupt reduction can produce an uneven jet and extra loss.
Equalising elementRedistributes flow while adding resistance that belongs in the selection.
Optional inlet damperProvides manual balance but can generate noise if severely throttled.
Diffuser faceDetermines discharge pattern and the relevant flow-measurement characteristic.

Evaluate full and reduced operating flows. A large neck does not ensure suitable room mixing or throw at low flow, and a deeper chamber alone does not prove uniform discharge. Measure the completed outlet and assess its interaction with adjacent terminals and room obstructions.

Cleanability and handover

Specify internal acoustic lining only with a suitable exposed surface, retention and cleaning method. Arrange external insulation and vapor sealing where required by the cold-air and ceiling-void conditions. The galvanized box is an air-distribution component, not a substitute for a sealed terminal filter housing.

The offer should identify duty, matched face, complete assembly weight, suspension, damper, measurement access and insulation. Acceptance includes secure supports, sealed interfaces, measured flow and accessible service points. Maintenance should check deposits, lining condition and the equalising element, restoring the original arrangement after cleaning.

Planning your Cleanroom Air Distribution Plenum Box 600 mm High-Capacity Diffuser with DN315 Spigot specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us