Chemical-Resistant Novolac Epoxy Flooring 4–6 mm Novolac-Sealed Screed
- 4-6 mm epoxy screed body
- Novolac resin at the exposed face
- Layered construction for combined duties
A load-bearing epoxy screed with a specialist chemical face
This 4–6 mm construction places a novolac epoxy seal over a conventional epoxy mortar body. Primer and trowelled screed provide the bonded bulk layer; a high-build epoxy coat and nominal 0.5 mm aluminum-oxide broadcast prepare a textured surface for the final seal. Novolac chemistry is at the exposed face, not throughout the mortar.
Protect the surface that provides chemical resistance
The screed distributes traffic loads into the slab while the final seal meets process liquids. If turning wheels or impacts wear through that seal, the exposed underlying epoxy has a different chemical-resistance basis. Inspect high-contact corners, loading points and spill zones and renew the compatible seal before the body becomes exposed.
The broadcast and seal amount determine the final gloss texture. A very heavy seal can bury the profile; too little can leave difficult-to-clean areas around aggregate. Assess a finished sample with the intended footwear, contamination and cleaning method. Aggregate size alone does not establish a tested slip class.
Build and cure each interface correctly
The base must be sound and suitably prepared, with repairs and moving joints addressed before placement. Compact the mortar uniformly and maintain its specified thickness at thresholds and drain approaches. Each subsequent coat needs its approved recoat condition; a cured, contaminated intermediate surface cannot simply be covered and assumed to bond.
Novolac selection depends on the actual chemical concentration, temperature and contact time. The maintenance topcoat must preserve that chemistry. Separate the release for walking, full traffic and chemical handling according to the selected system and recorded site conditions.
Supply and acceptance
A comparable quote identifies all stages: primer, epoxy screed, high-build coat, aluminum-oxide broadcast and novolac seal, together with coves, joints and preparation. Include any chemical-compatible drain and penetration details rather than treating them as ordinary trim. Acceptance should address thickness and compaction, intercoat bond, intact sealed texture and the agreed chemical suitability. Where secondary containment is required, specify the complete lining and joint design separately; a heavy screed with a chemical seal is not sufficient evidence of containment.
Planning your Chemical-Resistant Novolac Epoxy Flooring 4–6 mm Novolac-Sealed Screed specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.