Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Air Ducts & Air Distribution / Bubble-Tight Isolation Damper 610 x 305 mm
zhengfeng-BUBBLE-TIGHT-ISOLATION-DAMPER-610X305

Bubble-Tight Isolation Damper 610 x 305 mm

A rectangular centre-pivoted blade concentrates sealing around one perimeter, with actuation and leakage evidence selected for the branch duty.
  • One blade spans the rectangular opening without intermediate blade joints.
  • External sleeve bearings allow service access from the duct exterior.
Request a Quote Browse Products

One blade across a rectangular process branch

The 610 x 305 mm isolation damper places a double-skin rectangular blade across a nominal 2:1 passage. It rotates about a full-length central axle and seals at its perimeter. This avoids the multiple blade-edge joints of a louver arrangement, while retaining potential leakage paths at the shaft seals and body connections.

Specify shutoff evidence as well as dimensions

Bubble-tight performance must be stated at a test differential pressure and operating condition for the supplied size. AMCA 500-D provides laboratory methods; mentioning it does not demonstrate an AMCA certification or establish performance at every pressure. Operating pressure, blade leakage and casing or joint tightness need distinct evidence.

ItemReference construction
Opening610 mm wide x 305 mm high.
BladeSingle centre-pivoted rectangular double skin.
FramePainted steel, 304L or 316L stainless steel options.
SealingMechanically retained silicone perimeter seal and selected axle seals.
SupportFull-length stainless axle with external bolted sleeve bearings.
InterfacesFront/rear flanges; actuator mounting and position switches by selection.

Coordinate the axis and service side

The catalog arrangement uses a horizontal central axle. Show that orientation, the actuator side, blade sweep and flange hole pattern on the installation drawing. The nominal opening does not determine overall depth, mounting-hole centres or actuator clearance. A short adjacent transition must not obstruct blade travel.

External bearings improve access but do not make maintenance safe while the process remains connected. Provide the required isolation procedure and access to remove the seal and coupling. Support mating ductwork to avoid twisting the long flange edges; distortion can change the seal contact even when the actuator reaches its stop.

Torque, controls and chemical service

Select the actuator from the seating and opening torque for this blade, seal and pressure duty. The intended fail-open or fail-closed action, available power, operating time and position feedback must match the process sequence. End switches confirm a position, not the leakage result.

Choose 304L, 316L or coating and the silicone compound against the actual exhaust and cleaning exposure. A material upgrade does not automatically increase permitted pressure or make the seal resistant to every decontaminant. Inspect seat deposits, seal damage and shaft movement during maintenance and retest after relevant adjustments.

The quote should include actuation, switch contacts, mating flange seals, testing and spare perimeter seals. Handover should verify unobstructed stroke, the specified fail response and shutoff testing at the agreed pressure and directions. No numeric velocity or pressure rating is implied by the opening size alone.

Planning your Bubble-Tight Isolation Damper 610 x 305 mm specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us