Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Air Ducts & Air Distribution / Bubble-Tight Isolation Damper 1219 x 406 mm
zhengfeng-BUBBLE-TIGHT-ISOLATION-DAMPER-1219X406

Bubble-Tight Isolation Damper 1219 x 406 mm

A low-profile rectangular opening uses one wide blade and a full-length axle, with support and seating conditions coordinated for isolation.
  • The low, wide format fits shallow rectangular duct envelopes.
  • A continuous blade avoids a row of independently sealed louvers.
Request a Quote Browse Products

A low-profile opening with a long sealing perimeter

The nominal 1219 x 406 mm damper isolates a broad rectangular branch using one double-skin blade and a full-length axle. The approximately 3:1 format can suit a shallow duct envelope. Its low opening height does not describe the space required for the flanges, bearings, actuator or rotating blade.

A single blade removes intermediate louver joints, but a long blade and frame must still remain aligned to obtain continuous seal contact. Support, shaft stiffness and seating torque become central selection questions for this width.

Reference build and project ratings

ItemCatalog configuration
Nominal passage1219 x 406 mm.
BladeWide centre-pivoted double-skin rectangular construction.
Axle/bearingsFull-length stainless axle and external bolted sleeve bearings.
SealMechanically fastened, replaceable silicone perimeter element.
Casing optionsPainted steel, 304L or 316L stainless steel.
InterfacesRectangular flanges; selected drilling and powered quarter-turn option.
RatingsPressure, velocity, temperature and leakage evidence specific to the supplied size and actuation.

Large-damper installation is a sealing issue

Carry the damper and duct loads on appropriate supports. Drawing a distorted duct flange tight with the damper bolts can twist the seat and create local bypass. Check flange alignment, the correct gasket and bolt sequence, and blade clearance through the complete stroke before commissioning.

The actuator must move and seat the wide blade at the specified differential pressure. A small-size torque value cannot be scaled by width alone. Define the required power-loss action and feedback, and verify that linkage travel reaches the intended mechanical position without overloading the seal. A position signal cannot establish bubble-tightness.

What bubble-tight acceptance needs

Request a leakage report identifying the tested size, differential pressure, direction, closure conditions and method. AMCA 500-D is a test framework; it is not an unrestricted pressure rating or an assertion of third-party certification. Include the installed flange and shaft interfaces in the overall system leakage plan.

For decontamination service, qualify the silicone and metal finish for the actual chemical exposure. Leave access to remove the long seal without dismantling unrelated ductwork. Inspect continuous contact around the full perimeter after replacement and repeat the agreed functional and leakage tests.

Quotation should separate the damper, actuator, switches, lifting or support provisions, mating gaskets, seal spares and factory/site tests. A process shutoff assembly should not be substituted for a required fire/smoke or personnel-isolation device without the corresponding design and evidence.

Planning your Bubble-Tight Isolation Damper 1219 x 406 mm specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us