Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Blast-Resistant Cleanroom Door Stainless-Clad Service for Clean Facilities
zhengfeng-BLAST-RESISTANT-SERVICE-DOOR-SINGLE-SS-CLAD

Blast-Resistant Cleanroom Door Stainless-Clad Service for Clean Facilities

A stainless-clad steel leaf pairs with a painted steel frame for a specified protective personnel entrance.
  • Stainless cladding provides the exposed face without a painted leaf finish.
  • The single opaque blade maintains visual screening of service equipment.
  • Steel-frame construction remains independent of the selected face cladding.
Request a Quote Browse Products

Stainless cladding over a protective steel service door

This single opaque service door combines stainless external cladding with an underlying steel leaf containing protective panels. The surrounding welded-corner frame is painted steel. It suits a facility boundary where the exposed leaf finish is specified as stainless while the protective doorset retains its coordinated steel construction.

Separate finish selection from protective duty

The stainless grade, sheet finish, attachment and edge treatment belong in the material schedule. A brushed appearance does not identify the grade. Chloride exposure, cleaning chemistry and wet joints influence corrosion behavior; the painted frame, fasteners and concealed interfaces must also suit the environment. Water held behind cladding or at damaged coating edges can remain difficult to inspect.

Cladding is not a substitute for a documented protective assembly. Establish the project blast loading, direction and required post-event response, then match the leaf, frame, hardware and anchorage to the relevant evidence. Added cladding changes the completed leaf mass and hardware demands. It should be included in the assessed configuration rather than applied later as an unreviewed finish upgrade.

Service access and construction interfaces

Coordinate handing, usable clear width, swing area and routine opening effort with the personnel route. The frame needs a defined connection to supporting structure. Welded corners do not establish the capacity of the surrounding wall or its anchors. Select handles, latch and closer as a compatible set, including any separate emergency-access requirement.

Distinguish a primer-only frame from a finished painted frame in the quotation. Site touch-up and final coating must suit the exposure and the factory system. Avoid unapproved drilling through the leaf for signs, readers or kick plates; attachments can affect both protective evidence and corrosion details.

Quotation, evidence and maintenance

Include stainless grade and finish, cladding interfaces, frame coating, door dimensions, protective criteria, hardware, anchors, installation and supporting documentation. Handover should verify fixing records, finish condition, clearances, operation and full latching, with the supplied assembly traced to its assessment. These checks support installation acceptance but do not establish a new blast rating.

Routine service should inspect exposed stainless, painted edges, loose fixings and hinge or latch wear. Repairs and replacement hardware must preserve the documented configuration. Cleanroom air-leakage or fire performance, where required at the boundary, should be specified and evidenced separately.

Planning your Blast-Resistant Cleanroom Door Stainless-Clad Service for Clean Facilities specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us