Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Automatic Swing Door Operator Springless Slim
zhengfeng-AUTOMATIC-SWING-DOOR-OPERATOR-SPRINGLESS-SLIM

Automatic Swing Door Operator Springless Slim

A slim electromechanical drive moves the interior leaf without a return spring, with outage behaviour and arm geometry defined for the opening.
  • A 70 mm header profile suits constrained overhead space.
  • Push or pull arms accommodate the installation side.
  • Springless drive distinguishes the operator from spring-return hardware.
Request a Quote Browse Products

Slim powered movement without a return spring

This interior swing-door operator uses an electromechanical drive and an overhead arm to move the leaf. The springless construction removes the conventional closing spring from the drive. It suits openings where motor-controlled movement is appropriate and automatic closure after loss of power is not assumed.

The 70 mm housing-height reference is useful when the header is shallow, but it is not the entire installation envelope. The cover depth, arm sweep, shaft extension, mounting plate, cable entry and service clearance can determine whether the unit fits. Measure the complete doorway section before selecting the arm.

Resolve the power-loss condition first

Without a return spring, an open door cannot be assumed to close when electrical power disappears. Define the required position, manual operation and recovery after an outage. A cleanroom pressure boundary or interlocked airlock may need a different return arrangement if closure is essential during that condition.

An access-control release also needs coordination with the drive. The lock should release before the motor opens the door, while a closing command should not be treated as proof that the door is closed or locked. Use the actual feedback required by the room sequence.

Selection inputs for the opening

InputEffect on the installation
Leaf width, mass and pivot positionDetermine movement load together, rather than by mass alone
Interior pressure and sealsInfluence opening and closing resistance throughout travel
Push or pull sideDetermines compatible arm geometry and reveal limits
Single or paired leavesDefines operator quantity, synchronisation and any overlap sequence
Activation and protectionSeparate the request to open from detection in the moving-leaf area
Electrical scopeState mains supply, accessory loads, lock interface and outage behaviour

The existing product information does not establish a universal mass limit, opening speed or duty rating. Select these from the offered drive-and-arm combination. Two operators mounted side by side do not automatically provide the correct sequence for rebated double doors.

Commission the complete movement path

Before powered operation, check that the door runs freely and that the header and arm fixings have suitable reinforcement. Teach the travel using the selected procedure, then test activation, presence detection, lock release, normal closing and power restoration. Evaluate clearances at the hinge side and along the whole leaf sweep.

Keep the overhead cover accessible and include periodic checks of the arm, fasteners, sensors and manual movement. Provide the doorway drawing and required failure sequence with the enquiry. Where a mechanical closing reserve is needed, compare the spring-return operator.

Planning your Automatic Swing Door Operator Springless Slim specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us