Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Automatic Swing Door Operator Compact Retrofit
zhengfeng-AUTOMATIC-SWING-DOOR-OPERATOR-COMPACT-RETROFIT

Automatic Swing Door Operator Compact Retrofit

A compact drive upgrades a suitable existing leaf, with operating modes and accessory interfaces matched to its users and control sequence.
  • Compact format suits conversion work on existing entrances.
  • Push-and-go starts operation from an initial manual movement.
  • Ratchet mode supports a deliberate open-and-close control sequence.
Request a Quote Browse Products

Upgrade a suitable existing single leaf

The compact retrofit operator adds electromechanical movement to an existing swing door. It can reduce the need to replace the complete opening where the leaf, frame and hinges remain suitable. Low-energy operation and interfaces for a touchless switch, presence sensor and electric strike allow the operating sequence to be adapted to the entrance.

Retrofit feasibility begins with the door itself. Check hinge play, frame strength, available fixing positions, latch resistance and the full swing clearance. An operator should not be used to force a rubbing or distorted door through its travel. Existing closer hardware also needs to be assessed against the selected drive arrangement.

Choose a mode users can understand

Push-and-go starts a powered opening cycle after an initial manual movement. Free-swing operation allows a different manual-use behaviour, while ratchet control normally uses successive activation commands to change the open or close state. The exact supported modes and their response to repeated inputs must be agreed for the supplied unit.

Ratchet operation can leave the doorway open until another command arrives. It therefore needs particular consideration at a pressure boundary or interlocked entrance. A touchless switch reduces the need to touch a button, but it does not detect every person or object in the door sweep.

Survey and integration requirements

Existing conditionRequired decision
Leaf and frameVerify structure, width, mass and free manual movement
Overhead spaceCheck body, arm, reveal and cover access together
Latch or strikeDefine electrical release timing and confirmation if required
ActivationSelect deliberate switch, push-and-go or another supported input
Protective sensingAssess the actual swing area and user population
Failure and recoveryDocument power-off manual use and restored-power behaviour

Low energy describes a configured operating approach, not permission to omit the installation assessment or protective devices. Door mass, speed, timing and forces have to be evaluated for the applicable requirements. The product description alone is not evidence of compliance for the completed doorway.

Prove the conversion before handover

Test each enabled mode with the real lock and activation devices. Include a person remaining in the opening, repeated commands, an interrupted cycle and loss of power. Verify that the operator does not drive against a locked leaf and that an airlock controller receives the actual door state.

Hand over the selected settings and a simple user explanation of each enabled mode. Service access should allow arm, cable and sensor checks without damaging the surrounding finish. Include the operator, arm, fixing reinforcement, strike, switches, sensors and commissioning separately in the retrofit scope.

Planning your Automatic Swing Door Operator Compact Retrofit specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us