Automatic Hermetic Sliding Door Opaque Double-Leaf
- Bi-parting operation distributes moving panels to both sides.
- Solid HPL faces provide visual privacy across a wide entrance.
- Rotating lower guides reduce friction at the guiding contact.
A central opening for wider opaque passages
Two HPL-faced leaves move to opposite sides of this automatic entrance. This distributes the parking space and suits wide material passages with usable wall length on both sides. It still needs clear side zones; bi-parting operation cannot solve a doorway surrounded by equipment. The opaque leaves provide privacy, so controls and detection should accommodate traffic that cannot see through the closed door.
How the pair develops sealing contact
Near closure, the track draws each leaf downward and toward the wall. Recessed rubber seals contact the surround while lower rotating guides control the path. The center meeting joint introduces another sealing interface: equal alignment and the correct closing relationship matter as much as contact along the outer jambs. Track geometry and guides should release compression during opening without scraping the floor.
| Parameter | Interpretation |
|---|---|
| Leaf construction | 40 mm HPL-faced leaves with anodized aluminum edges. |
| Opening envelope | Up to 3000 mm total width and 3000 mm clear height as reference limits, subject to an approved size and load combination. |
| Moving load | 110 kg maximum reference per leaf; hardware and finish contribute to each leaf's mass. |
| Options | Mechanical or electrical locking and cantilever handles, coordinated with travel and manual access. |
Interfaces and maintenance
A supported continuous header, parallel sealing surfaces and level floor contact are essential across the broad opening. Include wall movement and floor finishes in the installation details. Keep guide cams accessible for cleaning and adjustment. Inspect the center seal for crushing or a gap caused by uneven leaf arrival; repeatedly increasing motor force can accelerate seal damage. Cleaning agents must suit HPL, anodized edges and rubber, including their joints.
Scope and acceptance
The quotation should identify both leaves, parking widths, reveal, header support, locks, operator, sensors, wiring and commissioning. Demonstrate full opening, center closure, obstruction protection, manual release and the specified power-failure state with the chosen locks installed. Establish an allowable leakage at the project's pressure and direction, using the complete assembled doorway. A wide opening and hermetic closing mechanism do not by themselves establish a fire rating or a particular air-leakage class.
Planning your Automatic Hermetic Sliding Door Opaque Double-Leaf specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.