Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Automatic Hermetic Sliding Door Opaque Laminate Single-Leaf
zhengfeng-AUTOMATIC-HERMETIC-SLIDING-DOOR-LAMINATE-SINGLE

Automatic Hermetic Sliding Door Opaque Laminate Single-Leaf

An opaque laminate leaf lifts away from its seals before powered sliding; planning includes parking space, safety controls and the complete sealing interface.
  • Opaque laminate preserves separation from the adjacent space.
  • Lift-before-slide movement releases the blade from its sealing contact.
  • The covered operator presents a cleanable overhead surface.
Request a Quote Browse Products

Opaque separation with a seal-release opening sequence

This automatic single slider serves laboratory and pharmaceutical entrances where a swing would obstruct circulation and observation through the door is unwanted. Laminate covers both faces. The linear lifting actuator first releases the closed leaf from its rubber wall and floor contacts; the toothed belt then moves the leaf sideways. Releasing contact before travel limits continuous gasket rubbing, but requires correct timing between the two movements.

Dimensions, controls and operating duty

Planning itemConfiguration and selection consequence
Clear opening800–2500 mm reference range; allow additional leaf overlap and a full parking area beside the opening.
Moving massRecommended maximum 200 kg; include the complete finished leaf, handles and accessories when selecting the operator.
Electrical supply120–240 V AC, 50/60 Hz; 250 W maximum consumption reference. Final supply, protection and accessory loads belong on the approved electrical schedule.
ClosureRubber perimeter contact and a flat underside gasket; leakage depends on the installed assembly and pressure direction.

Width and mass limits must be checked together with traffic frequency. Hold-open time should accommodate the actual trolley movement without unnecessarily extending the period in which the pressure boundary is open. Touchless activation requests movement; presence detection protects the passage and needs separate commissioning.

Installation and service access

Provide structural support for the header, a flat sealing surround and a continuous floor contact surface. A hollow partition skin alone is unsuitable as the support design. Reserve access above the cover for servicing the lift actuator and belt. Clean laminate faces, edge joints and rubber with compatible agents; inspect for swelling, cuts and uneven compression. Increasing closing force cannot repair an uneven floor.

Quotation and acceptance

Include the door and reveal, supports, seals, operator, activation and safety sensors, electrical interfaces and commissioning in the scope. Optional battery operation needs a defined duration or cycle requirement and an end-of-charge state. Demonstrate powered cycling, manual opening after the specified release, obstruction response and recovery after power loss. Where airtightness is required, agree the pressure, direction and allowable leakage for the complete installed door; the opaque laminate finish does not establish that result.

Planning your Automatic Hermetic Sliding Door Opaque Laminate Single-Leaf specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us