Automatic Door Drop Seal Slim Mortised
- Fully mortised installation hides the carrier.
- Self-levelling action accommodates small floor variations.
- Mechanical operation avoids a separate electrical supply.
A concealed seal that moves only at closure
The slim mortised drop seal fits within a prepared groove along the bottom of a suitable metal door. As the leaf closes, a mechanical plunger meets its opposing surface and lowers the gasket toward the threshold. Opening releases the mechanism so the gasket rises, avoiding the continuous dragging action of a fixed sweep.
Concealment preserves the door-face appearance and reduces exposed carrier surfaces. It also makes the bottom preparation part of the door design. A thin metal skin or hollow bottom edge cannot be assumed to provide the same support as a reinforced groove prepared by the door fabricator.
Plan the groove and replacement route
Match the carrier section, fixing method and available bottom-rail depth to the selected seal. Keep the mounting straight and clear of swarf so the moving parts are not pinched. Consider how the carrier will be removed later, including whether the leaf must be taken down or opened far enough to access the fixings.
Length selection includes end fittings and permitted trimming. Cut only from the allowed end and within the limit for that size; internal linkage prevents arbitrary shortening. Plunger location and the opposing contact detail must follow the supplied instructions.
Floor and threshold conditions
| Condition | Selection or adjustment implication |
|---|---|
| Closed-door gap | Measure across the whole width and stay within the offered travel range |
| Small floor slope | Self-levelling can distribute contact within the mechanism capability |
| Deep joints or uneven finishes | A suitable threshold plate may provide a continuous contact surface |
| Opening path | The retracted gasket must clear the actual floor throughout the swing |
| Cleaning regime | Check gasket and carrier compatibility with cleaning agents |
| Other edge gaps | Coordinate jamb, head and meeting-stile seals where relevant |
Self-levelling is limited adjustment, not a way to bridge steps or fill every floor defect. A bottom seal contributes to closing a leakage path; by itself it does not establish a room-pressure, acoustic, smoke or fire rating.
Adjust for contact without dragging
Set the plunger so the gasket meets the threshold near the final closing position. Excessive travel can buckle the gasket, increase closing resistance or prevent latching. Test slow closure and opening from the latched position, watching both ends of the seal.
During maintenance, remove debris from the contact surface and inspect the gasket for tears or permanent deformation. Recheck after flooring changes, hinge work or seal replacement. If the existing leaf cannot accept the required groove, consider the face-fixed drop seal and assess its added projection.
Planning your Automatic Door Drop Seal Slim Mortised specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.