Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Automatic Door Drop Seal Heavy-Duty Dual-Gasket
zhengfeng-AUTOMATIC-DOOR-DROP-SEAL-HEAVY-DUAL-GASKET

Automatic Door Drop Seal Heavy-Duty Dual-Gasket

A substantial mortised carrier combines outer and internal silicone gaskets with parallel drop and spring retraction.
  • Two gasket layers provide a distinct sealing arrangement.
  • Parallel travel keeps the sealing element aligned.
  • Independent adjustment accommodates an uneven threshold.
Request a Quote Browse Products

A deeper carrier with two sealing elements

The heavy-duty mortised drop seal combines a wraparound outer gasket with an additional internal silicone element. A spring-loaded parallel mechanism lowers the sealing section as the door closes and lifts it clear as opening begins. The substantial carrier requires a suitable bottom preparation rather than the shallow space used by a slim seal.

Two gaskets create a different sealing path, but do not independently guarantee a higher acoustic or leakage rating for every door. Performance depends on contact, the remaining perimeter gaps and the construction of the leaf and frame. The complete installed assembly is the basis for any specified test result.

Match the preparation to the working gap

The listed reference operating gap is 6–15 mm. Measure the actual clearance at several points across the closed leaf before selecting the carrier position. A maximum drop value does not mean any floor profile within that height will seal continuously. Self-levelling accommodates limited variation; deep joints, steps or loose floor finishes require separate treatment.

Maintain sufficient material and reinforcement around the mortise, and leave the end fixings accessible. A tight or distorted groove can interfere with parallel movement. Coordinate any threshold plate with the intended traffic and cleaning process.

Reference construction and order details

ItemReference or selection requirement
CarrierMortised aluminium with silver anodised finish
Sealing elementsGrey silicone outer wraparound and additional internal gasket
MechanismParallel, spring-loaded retraction with independent levelling
Gap reference6–15 mm, checked against the offered size and mounting detail
Length reference335–1235 mm in listed sizes, with size-specific trimming limits
End detailsCompatible end plates, actuator contact and fixing arrangement

Do not order solely from the nominal leaf width. Account for end fittings, usable gasket length and the allowed cutting end. Different sizes can have different minimum cut-back lengths because of the internal mechanism. For double leaves, coordinate both bottom seals with the meeting stile and closing order.

Commission both contact and retraction

Adjust the actuator until the seal contacts the threshold near the final closing position without excessive compression. Check the entire width and verify that both gasket elements remain correctly seated. Then open slowly and confirm prompt clearance, no folded rubber and normal latch operation.

Inspect the internal and outer elements separately during maintenance, since visible outer contact can conceal damage to the inner gasket. Keep grit away from the contact line and use compatible cleaning agents. After replacing a gasket or adjusting hinges, repeat the travel and latching checks. Any required acoustic, smoke or fire evidence must match the offered assembly and installation rather than a similar-looking seal.

Planning your Automatic Door Drop Seal Heavy-Duty Dual-Gasket specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us