Automatic Cleanroom Sliding Door Telescopic
- Two panel stacks use side parking space efficiently.
- Four narrower moving leaves serve a broad central passage.
- Telescopic travel provides an alternative where full-width blade parking is limited.
A broad central entrance using two telescopic stacks
Four moving glazed leaves form two telescopic pairs that part from the centre. Within each pair, the panels overlap along parallel paths as they park. This can reduce the required runback width compared with ordinary bi-parting leaves serving the same passage, while increasing the depth and number of moving interfaces.
The selected arrangement has four moving leaves. It is distinct from a three-panel manual entrance with two moving leaves and one sidelite. Define any stationary side panels separately so the drawing, operator capacity and quotation refer to the same package.
Reference dimensions and coordinated loads
| Item | Planning reference |
|---|---|
| Clear opening | 1200–4000 mm total width, within the selected four-leaf system's permitted combination. |
| Height | Up to 3000 mm, subject to glazing and load constraints. |
| Leaf mass | 80 kg per moving leaf reference maximum. |
| Drive | Synchronized overhead telescopic drive serving two overlapping pairs. |
| Construction | Aluminum-framed glazing with parallel tracks; finish, glazing profile and touchless activation selections. |
Each panel has its own mass and permitted geometry; adding four individual load limits does not create a general capacity for any panel distribution. Maximum width and height must be checked alongside glass specification, frame weight, overlaps and operating duty. The approved layout determines the resulting clear opening.
Installation and operating protection
Reserve header depth and stack clearance for both parallel tracks. Support the full header span and provide access to every roller and linkage adjustment. Panels travel at coordinated rates to stack correctly, so poor synchronization can cause collisions or insufficient clear passage.
Identify trapping zones between overlapping leaves and at both parking areas, as well as the central closing zone. Specify sensing, protective details, control modes and power-failure behavior for the complete entrance. An opening-request sensor alone cannot protect all these interfaces.
Service and commissioning scope
Inspect track cleanliness, guides, belts or linkages, panel alignment and changes in travel timing. Arrange cleaning access between stacked panes rather than leaving hidden faces inaccessible. Recommission affected movement and safety functions after linkage or sensor work.
Quote the four-leaf assembly, complete drive and safety package, glazing, controls, structural/electrical installation and tests. Handover should demonstrate full and any partial-opening modes, coordinated stacking, required presence detection and specified fault responses. The more compact runback does not establish airtightness or suitability for an escape route without the corresponding system design.
Planning your Automatic Cleanroom Sliding Door Telescopic specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.