Automatic Cleanroom Sliding Door Single-Leaf
- One moving blade simplifies the entrance layout.
- Belt transmission avoids a swinging leaf in the approach zone.
- Glazed construction permits a clear view of the next space.
One powered leaf parking to one side
This automatic slider moves one aluminum-framed glazed leaf along an overhead track. A toothed belt transmits the operator's movement, while rollers and lower guidance maintain the panel path. The arrangement suits entrances with enough side parking space and can use touchless activation for staff carrying materials.
An activation device requests opening; it does not replace detection protecting someone who remains in the passage or near the moving panel. The safety layout must cover the actual entrance, including the closing edge and any opening-side trapping zone.
Size and load must be selected together
| Parameter | Reference planning range |
|---|---|
| Clear width | 800–3000 mm, subject to the selected assembly's size-and-load envelope. |
| Clear height | Up to 3000 mm within that envelope. |
| Leaf mass | 150 kg reference maximum; include glass, frame, handles and all moving accessories. |
| Face/profile | 10 mm single glazing with a 20 mm aluminum-profile configuration; insulating-glass framing optional. |
| Drive/support | Overhead belt operator with plastic running rollers and ball-bearing guide pulleys; wall or passage mounting. |
Maximum width, height and mass are separate constraints, not a promise that all maxima can occur together. A taller or heavier glazing unit can reach the drive limit before the width limit. Verify the finished leaf calculation and the operator/profile data for the requested combination.
Interfaces and maintenance
Provide structural header support, a power supply and the required activation, presence-sensing, access-control and alarm interfaces. Define power-failure and emergency behavior for the route; backup power or breakaway operation is not implicit. Ordinary automatic movement does not make the door hermetic.
Leave service access to the belt, controller and rollers. Keep guides and sensing zones clear, and have qualified service personnel investigate abnormal movement, belt wear or repeated reversal. Do not reduce detection coverage to suppress nuisance triggering.
Quotation and commissioning
Quote the complete entrance, operator, sensors, controls, wiring, structural work, glazing, seals and commissioning. Provide traffic type, room pressure and equipment envelopes. Acceptance should demonstrate detection of representative users and stationary obstructions using the approved test procedure, correct modes and interfaces, clear opening and recovery after the specified fault conditions. Record the final settings and maintenance instructions.
Planning your Automatic Cleanroom Sliding Door Single-Leaf specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.