Automatic Cleanroom Sliding Door Bi-Parting
- A central opening supports an intuitive approach line.
- Opposing leaf travel shares the parking requirement between both sides.
- Synchronized movement keeps the pair operating together.
Two powered leaves creating a central opening
The bi-parting system moves two framed glass leaves away from the centre under a shared belt-driven operator. Each leaf parks on its own side, keeping the approach aligned with a central corridor. Both return spaces and the meeting edges must be included in the entrance layout.
Synchronized travel means the drive coordinates the panels. It does not prove that the centre gap, floor guidance or safety fields are correct. A displaced hanger or guide can make one leaf reach its closed position early and disturb the entire closing action.
Reference selection envelope
| Item | Planning reference |
|---|---|
| Clear width | 800–3000 mm for the combined opening, subject to the selected system. |
| Height | Up to 3000 mm within the allowed size/load combination. |
| Leaf load | 120 kg per leaf reference limit, including all moving parts. |
| Glazing/profile | 10 mm single glazing in a 20 mm aluminum-profile configuration. |
| Motion | Synchronized toothed-belt drive and guided rollers; touchless activation and insulating-glass framing options. |
The load limit applies to each leaf. Unused capacity on one side does not automatically permit an overweight panel on the other. Wider or taller glass, locks and heavier insulating units must be included in the final mass and mounting selection. The maximum dimensions are not automatically simultaneous.
Safety fields and system interfaces
Plan presence detection across the passage and protection at both side parking areas where trapping is possible. Touchless request switches are activation controls, not substitute safety sensors. A partial-opening mode must still provide the required clearance and detection coverage.
Coordinate power, access control, lock monitoring and the approved response to alarm or power loss. The shared drive and header require stable support and maintenance access. Adjust seals without creating excessive friction or masking a timing problem.
Maintenance, price and acceptance
Inspect both guide paths, the central meeting alignment, belt and rollers. Repeated reversals or changing centre gaps warrant service rather than simply increasing force. The quote should include the full two-leaf assembly, operator, sensors, controller interfaces, electrical/structural work and commissioning.
Acceptance verifies total clear width, synchronized movement, safe response to representative presence and obstruction tests, both opening-side zones and the specified failure modes. Any smoke, fire or pressure-boundary performance requires the appropriate complete-door evidence, independently of automatic operation.
Planning your Automatic Cleanroom Sliding Door Bi-Parting specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.