Antistatic Epoxy Flooring Polyurethane-Capped
- Conductive epoxy body with a functional PU cap
- Nominal 1.5–2.0 mm layered arrangement
- ESD performance rechecked after surface renewal
An epoxy floor body with a functional polyurethane cap
zhengfeng PU-CAPPED-20 combines a conductive epoxy body with a separate waterborne polyurethane ESD topcoat. The nominal 1.5–2.0 mm layered construction is intended for interior electrostatic protected areas that need a smooth matte face. The epoxy establishes the main resin body, while the polyurethane cap is the surface contacted by footwear and cleaning equipment.
This arrangement can make surface renewal more practical when the body remains sound. It does not make the topcoat interchangeable with an ordinary decorative polyurethane. Its electrical properties, bond and permitted application thickness must remain compatible with the conductive layers beneath it.
Keep the complete charge path intact
The floor arrangement includes a prepared and primed substrate, earthing connections, a conductive primer, the epoxy body and the ESD cap. The functional layers must provide a continuous route to the specified ground connection. A conductive body covered by an insulating finish can leave the operating surface outside the intended electrical behaviour.
Plan connections and accessible test locations around room boundaries, joints and separate floor areas. Have the grounding arrangement coordinated with the facility electrical design. Neither a dark primer nor a visible earthing strip demonstrates that all finished areas are correctly connected.
Select the cap for appearance and service
The matte finish can reduce reflections in assembly and inspection rooms, although light levels and surface colour still affect visibility. Daylight stability and yellowing resistance depend on the actual polyurethane formulation; an interior ESD cap is not automatically an exterior coating. Approve a finished colour and sheen sample.
The cap receives direct abrasion and chemical contact. Identify castor-chair use, turning wheels and cleaning agents when selecting its coating schedule. Increasing thickness or substituting a more chemically resistant finish without checking the system can change the electrical contact surface.
Renew the finish without hiding a deeper fault
Before refurbishment, distinguish ordinary topcoat wear from loss of adhesion, damaged conductive layers or a failed ground connection. Cleaning and recoating alone will not repair those deeper defects. Prepare the existing surface and apply the specified replacement cap within the compatible recoating procedure.
A renewed surface must be commissioned again. Check the installed floor and qualify the intended footwear with it, including body voltage during walking. IEC 61340-4-5 addresses the person, footwear and floor combination; a previous result for a different cap or shoe does not establish the performance after renewal.
Procurement and routine control
Specify the layer schedule, nominal build, grounding drawing, intended shoes, cleaning process and acceptance criteria before installation. Record test conditions and locations for future comparison. Maintain the floor with compatible cleaners and avoid unapproved polishes that alter the contact surface. Repeat the relevant checks after repair, coating renewal or a footwear change, and retain the results with the facility ESD programme rather than relying on appearance alone.
Planning your Antistatic Epoxy Flooring Polyurethane-Capped specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.