Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / Aluminum Honeycomb Cleanroom Sandwich Panel 75 mm HPL-Faced
zhengfeng-ALUMINUM-HONEYCOMB-CLEANROOM-SANDWICH-PANEL-75-HPL

Aluminum Honeycomb Cleanroom Sandwich Panel 75 mm HPL-Faced

A laminate working surface depends on the selected grade, bonded backing and protected edges.
  • Laminate surfaces avoid painted metal on the room face.
  • Sealed edges protect the layered construction.
Request a Quote Browse Products

A laminate-faced honeycomb partition for occupied work areas

This 75 mm panel places high-pressure laminate, or HPL, on both sides of an aluminum-honeycomb construction. It is a finish option for cleanroom support areas and circulation zones where routine wiping and surface wear influence selection. The laminate provides the visible working surface, while the bonded core and perimeter support the panel.

Laminate thickness changes the construction

The reference face range is 0.8–4 mm, with matt or satin finishes, a 1150 mm standard module and a 980 mm option. Thin laminate bonded to a substrate and thicker laminate products are not equivalent merely because both are called HPL. Define the actual grade, face thickness and backing arrangement. Within a fixed 75 mm finished section, changing the faces changes the available core depth, mass and connection geometry.

HPL is made with resin-impregnated layers. An aluminum core therefore does not make the complete panel noncombustible. Any required fire classification must cover the laminate, adhesive, core, edge construction and installation. Likewise, a wear-resistant face is not a rating for repeated trolley collisions: an impact can damage the bond or crush the underlying cells before obvious surface wear develops.

Protect vulnerable edges and joints

Coordinate the interlocking profile with movement allowances, seals and trims. Edge finishing matters around door frames and service openings because these areas expose the laminate-to-core transition. Use designed backing where fittings impose local pull-out or clamping loads. In traffic routes, position appropriate protection so that expected impacts are transferred through a planned fixing arrangement.

Use the cleaning procedure approved for the selected laminate and joint materials. Strong chemicals or liquid retained at an unfinished edge can affect layers that are not represented by the visible surface. Test any special disinfectant regimen on the specified build. Inspect lifting edges, cracked corners and loose faces during maintenance, and repair the construction rather than masking a failed bond.

Quotation and acceptance details

Price the laminate grade and thickness on both faces, colour and finish matching, module layout, reinforced openings, trims and installation. Agree supported wall heights separately from available manufacturing lengths. Acceptance should compare the finish with an approved sample and check dimensions, bond evidence, edge closure, joint alignment and the actual support layout. Cleanability, loading and fire requirements each need their own applicable evidence.

Planning your Aluminum Honeycomb Cleanroom Sandwich Panel 75 mm HPL-Faced specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us