Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Aluminum Cleanroom Door 1000 mm Half-Vision Aluminum-Faced
zhengfeng-ALUMINUM-CLEANROOM-DOOR-1000-HALF-VISION

Aluminum Cleanroom Door 1000 mm Half-Vision Aluminum-Faced

A single aluminum-faced leaf combines a listed 1000 mm clear passage, upper glazing and enclosed mineral infill in the opaque sections.
  • Half glazing supports visual contact through the closed entrance.
  • The lower metal-faced section maintains partial privacy.
  • A 1000 mm clear width offers more passage room than the compact opaque model.
Request a Quote Browse Products

A wider single leaf with upper observation glazing

The 1000 mm clear-width aluminum-faced door combines upper-half glazing with rock-wool-filled opaque sections. It provides more viewing area than a compact vision light while retaining an opaque lower panel. The glass position should be selected for the users' eye height and the approaching traffic: a lower opaque section may still hide a cart or small equipment.

The larger single leaf requires a larger swing area than the compact model. Glass and mineral infill contribute to the completed leaf mass, so hinges and closer selection should follow the finished assembly rather than the assumption that an aluminum-facing door is always light.

Reference dimensions and composition

ItemListed configuration and detailing
Clear width1000 mm at the agreed open position; verify hardware projections.
Published height2125 mm; distinguish clear opening from leaf and frame dimensions on the drawing.
Opaque faces1.2 mm prepainted aluminum with enclosed rock wool.
Perimeter/frame profile2 mm extruded aluminum; actual leaf and wall interface sections to be scheduled.
VisionUpper half glazing with specified safety glass, retention and perimeter seals.
OperationManual single hinged leaf; handing, stainless handle and matching closer options.

Rock wool is a core material, not evidence that the glazed door is fire resistant. Any rated application must cover the complete glass, frame, seals, hardware and leaf design. The same applies to acoustic performance: a mineral-filled opaque portion cannot define the result for the whole glazed opening.

Practical installation and service

Set the frame on adequate partition reinforcement and check its diagonals before final fixing. The larger leaf gives greater leverage at the hinge jamb; thin wall facing alone is not a suitable support assumption. Allow clearance between the closer arm and adjacent ceiling or wall surfaces.

Specify the threshold and gasket arrangement as part of the room air-balance detail. Excessive compression can make opening difficult, while incomplete contact can allow uncontrolled leakage. During maintenance inspect glazing retention, sealed edges around the mineral infill and coating damage at likely cart contact points. Do not treat the opaque lower sheet as a rated impact panel without supporting evidence.

Procurement and acceptance

The quotation should identify the clear opening, viewing elevation, glass type, selected profile, infill, hardware, seals, wall preparation and fitting. Check finish samples and cleaning compatibility for the aluminum coating and glazing seals. Handover should include sightline and clear-width measurements, secure glass retention, uniform clearances and reliable closing under operating room pressure. Where ordinary manual effort cannot be achieved for the intended users, reassess the complete operating arrangement.

Planning your Aluminum Cleanroom Door 1000 mm Half-Vision Aluminum-Faced specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us