All-Aluminum Cleanroom T-Grid Medium-Strut Self-Supporting
- Support members are integrated between the ceiling modules.
- Prefabricated frames reduce the number of loose grid pieces assembled overhead.
- The modular openings accept tiles, filtration units and lighting.
Carry a compact ceiling from the enclosure frame
This configuration combines preassembled aluminium T-bar sections with support struts between the modules. Reference geometry includes a 50.8 mm grid face and 50.8 × 101.6 mm strut section, with 6063-T5 aluminium and a clear-anodized finish. It is intended for an enclosure-supported ceiling where overhead building attachment is inconvenient.
The grid transfers component loads into the struts, then into the enclosure supports and their anchors. Self-supporting describes that load path; it does not remove the need to design the wall frame and supporting floor for the reactions.
Select from the real load layout
List the weight and position of filters, lights, blank tiles and accessories before choosing the span. Concentrated loads, uneven loading and deflection can govern even when the total ceiling weight seems modest. Section dimensions alone do not establish an allowable room width.
The reference component format is nominally 2 × 4 feet, approximately 609.6 × 1219.2 mm. Distinguish the nominal module from the actual component outside size, clear opening and gasket-bearing overlap. A 600 × 1200 mm component may require a different frame layout.
Assembly and sealing
Support and secure each prefabricated frame in the designed sequence. Shipping modules reduce loose assembly pieces but their joints still require correct connectors and alignment. The supporting enclosure must be level and stable before the ceiling is loaded.
Complete gasket paths at frame intersections and the room perimeter. Select tile retention for the pressure direction and maintenance conditions. Hold-down connectors retain infills; they do not increase strut capacity or make the ceiling walkable.
Quotation and acceptance
Provide the room footprint, clear span, wall-frame details, component schedule and maintenance method. Quote struts, frames, connectors, bearings, anchors, gaskets, retainers and finish together, identifying components supplied separately.
Accept the structure against the approved load and deflection design, then inspect seating, joint levels and seal continuity. Keep access from above outside the scope unless specifically designed. After maintenance, reseat removed components and inspect their gaskets. Any cleanroom leakage or classification requirement must be assessed on the installed enclosure and ventilation system.
Planning your All-Aluminum Cleanroom T-Grid Medium-Strut Self-Supporting specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.