Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Wall & Ceiling Systems / All-Aluminum Cleanroom T-Grid Heavy-Truss Self-Supporting
zhengfeng-ALL-ALUMINUM-CLEANROOM-T-GRID-HEAVY-TRUSS

All-Aluminum Cleanroom T-Grid Heavy-Truss Self-Supporting

An overhead truss provides a designed support zone above gasketed modular ceiling frames.
  • The truss provides a distinct structural support zone above the ceiling plane.
  • A wider enclosure can be covered while retaining modular ceiling components.
  • Separate connector and hold-down options secure the assembled frame and infills.
Request a Quote Browse Products

Place the main support structure above the ceiling plane

This system uses an overhead truss in conjunction with aluminium struts and gasketed T-bar frames. The reference grid face is 50.8 mm, with 6063-T5 aluminium framing and clear anodizing. The ceiling retains modular positions for compatible filters, lights and blank panels below the structural zone.

A triangulated truss transfers forces through its chords and diagonal members to the supports. This can address span or loading needs that a simple strut arrangement cannot meet, but the result depends on truss depth, connections, bracing and bearing conditions.

Allow room for the truss and its reactions

Measure the available height above the finished ceiling before selecting the structure. Ducts, filter housings, sprinkler routes and maintenance access must coexist with the truss. A regular ceiling pattern below does not mean that every space above remains unobstructed.

Specify the actual clear span and complete component load plan. Check concentrated loads, maintenance loads where applicable, deflection and end reactions. The enclosure posts, floor anchors and any supporting building structure must be designed for those reactions. No single maximum room width applies independently of the chosen construction.

Install and load in a planned sequence

Trusses need the specified connections and stability during erection as well as in service. Provide the necessary handling access and temporary restraint before installing ceiling equipment. Do not hang unlisted services from convenient truss members.

The reference component format is nominally 2 × 4 feet, approximately 609.6 × 1219.2 mm. Match actual module sizes, bearing ledges and seals to the frames. Ceiling-to-strut connectors and infill hold-downs perform different functions and should be separately scheduled.

Commercial scope and acceptance

Quote trusses, bracing, struts, grid modules, connections, bearings, anchors, lifting arrangements and component retention. Identify whether any designed maintenance platform is included. A heavy-truss ceiling is not automatically a walking deck.

At handover, compare installed members and loads with the approved drawings, inspect bearings and connections, and check ceiling level and gasket continuity. Retain the load schedule for future equipment changes. Structural capacity does not establish air-tightness or room cleanliness; those require their own agreed verification on the complete installed system.

Planning your All-Aluminum Cleanroom T-Grid Heavy-Truss Self-Supporting specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us