Your One-Stop Supplier for Cleanroom Equipment and Aseptic Facility EssentialsInternational Project Support
Open mobile navigationClose mobile navigation
Home / Products / Cleanroom Doors, Windows & Interlocks / Airtight Cleanroom Swing Door Three-Side Gasket and Drop-Bottom
zhengfeng-AIRTIGHT-CLEANROOM-SWING-DOOR-DROP-BOTTOM

Airtight Cleanroom Swing Door Three-Side Gasket and Drop-Bottom

An HPL-faced swing leaf pairs head-and-jamb EPDM gaskets with a retracting floor seal for a threshold-free opening detail.
  • A moving bottom seal leaves no raised sealing sill.
  • Three-sided EPDM contact follows the head and jambs.
  • An anodized frame provides a finished aluminum wall interface.
Request a Quote Browse Products

Separate side seals and a retracting floor seal

This HPL-faced swing door uses EPDM gaskets at the head and jambs, plus an automatic guillotine-type seal at the bottom. The lower element retracts for travel and descends as the door closes. This can provide a clear passage for carts without a raised sealing sill, while retaining a deliberate sealing line below the leaf.

The junctions between the bottom seal and side gaskets are critical. A well-adjusted central section can still leak at the lower corners. Floor flatness, joints, slope and gasket end details must be assessed as a system. The phrase barrier-free refers here to the intended threshold arrangement; whole-route accessibility also depends on clear dimensions and operating effort.

Reference construction

ComponentListed specification
Leaf50 mm single hinged leaf, HPL facing; stainless face option.
FrameFlush anodized aluminum profile.
Side/head sealsThree-sided EPDM gasket.
BottomAutomatic retracting guillotine seal, with travel and floor-contact detail matched to the opening.
Hinges/closerStainless three-point hinge arrangement; compatible concealed closer optional.

Specify hinge count, model and fixing reinforcement in the hardware schedule; a three-point arrangement does not establish three-axis adjustment or a load capacity. A concealed closer also needs sufficient reinforced space inside the leaf or frame. HPL and stainless facing choices may change leaf mass and cleaning requirements, so the same hardware setting is not automatically suitable for both.

Set-up and service

Install the frame squarely and coordinate finished floor levels before final door adjustment. Set drop-seal actuation to establish contact without dragging on opening. Do not exceed the seal's permitted travel or shorten its mechanism beyond the selected manufacturer's instructions.

Clean the floor contact area and inspect the gasket lip and end closures for wear. Loss of sealing may result from debris, hinge sag or an uneven floor, not just a worn rubber insert. Retain access to the removable sealing element for replacement.

Quotation and handover checks

Include leaf finish, frame, gaskets, complete drop-seal mechanism, closer if required, installation and floor-interface work in the price. Acceptance should cover cart passage, full gasket retraction, contact at both lower corners and repeatable closing with room ventilation operating. Where quantified airtightness is required, document the test pressure and leakage criterion for the installed door; gasket material alone supplies no rating.

Planning your Airtight Cleanroom Swing Door Three-Side Gasket and Drop-Bottom specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team
Inquiry Form

Home

Products

News

About Us

Contact Us