Airtight Cleanroom Door Gasket Inflatable Silicone
- Retraction reduces contact during door movement.
- Joined-loop construction suits a continuous perimeter.
- An air connection distinguishes the active seal from passive profiles.
Expand after closure and retract before movement
The inflatable silicone gasket creates contact by expanding a hollow profile against the mating surface. After the door is closed and secured, a controlled air supply inflates the seal. Releasing that air allows retraction before the door moves. This separates the sealing action from the force needed to swing or slide the leaf.
The component is the gasket assembly, including its specified connection and geometry. A complete installation also needs a suitable retaining arrangement, pneumatic equipment and a control sequence. A hollow passive bulb cannot be substituted merely because its cross-section looks similar.
Design pressure together with gap and direction
Inflation pressure depends on the profile construction, expansion direction, gap, process pressure difference and required contact. A generic family range is not a commissioning setpoint. Excess pressure can overstress the seal, joints or retention without correcting an oversized gap.
Define the gap with the seal deflated, including manufacturing tolerance and movement under load. Corners require enough space for the chosen expansion geometry without wrinkling or stretching. The air connection must be accessible and protected from bending loads, moving hardware and cleaning damage.
Gasket and pneumatic schedule
| Item | Required definition |
|---|---|
| Loop geometry | Perimeter dimensions, corner radii, joints and expansion direction |
| Profile and compound | Working gap, inflation limit, temperature and chemical compatibility |
| Air connection | Port type, location, tubing support and replacement access |
| Supply treatment | Compatible gas quality, regulation and overpressure protection |
| Control | Inflation valve, exhaust path and pressure monitoring as specified |
| Fault response | Behaviour during loss of air, electrical supply or pressure confirmation |
Interlock the sequence with the door
Inflation should follow confirmed positioning of the door. An opening request should start deflation and permit movement only after the required release condition has been met. Pressure at a supply manifold does not necessarily prove that the gasket has retracted, especially with long tubing, a restricted exhaust or a trapped branch.
Define the sensing and timing needed for the actual system. Pressure confirmation also does not establish the achieved leakage rate. The door lock, seal state and room-pressure state have different meanings in a containment sequence.
Acceptance and replacement
Test the loop for leakage, inflation and complete retraction using the specified pressure and procedure. Then test the installed door at its required differential pressure, including air loss and an interrupted cycle. Examine corners and the connection while cycling.
Inspect for abrasion, cracks, loose retention and contamination on the mating surface. Isolate and depressurise before replacement. Keep the approved profile drawing, pressure settings and connector details with the maintenance record so a replacement loop does not require an improvised control adjustment.
Planning your Airtight Cleanroom Door Gasket Inflatable Silicone specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.