Three-quarter view of activated carbon pocket filter with multiple dark tapered bags

Penapis udara dan penapisan kimia

Penapis poket karbon diaktifkan

A multi-pocket filter combining particulate media with a distributed activated-carbon layer to remove fine dust and light-duty gaseous contaminants in one HVAC stage.

Particle and Gas Filtration
Conical Pocket Geometry
Distributed Carbon Layer
Large Media Surface

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The activated carbon pocket filter combines an upstream particulate layer, a bonded activated-carbon layer and a stabilizing downstream support within multiple tapered pockets. The long pockets provide a much greater media area than a flat panel and distribute both particle loading and carbon adsorption over the airflow. Stitched or ultrasonically welded spacers keep the pockets separated, while a steel or molded-polymer header fits standard bag-filter housings. It is intended for indoor-air-quality duty where moderate odors and particulates must be addressed without installing two separate filter stages.

Ciri-ciri Utama

A composite pocket medium captures particles and adsorbs light concentrations of gaseous pollutants in the same airflow pass.

Tapered pockets remain separated at design flow and use the available housing depth efficiently.

The distributed carbon layer exposes adsorbent across a broad area instead of concentrating it near the header.

A rigid header provides a familiar replacement interface for standard front- or side-access bag-filter systems.

Penyelesaian untuk permohonan anda

Separate particle and molecular stages consume valuable air-handler length, yet a thin carbon panel may not provide enough active area for the required airflow.

The air handler lacks space for a particle filter followed by a separate carbon cassette.Composite pocket media combines both functions within one standard bag-filter stage.

Flat carbon media has too little exposed area at the system airflow.Multiple deep pockets increase the available carbon-coated surface behind the same face opening.

Bag pockets touch and block one another at reduced airflow.Tapered geometry and internal spacing retain open channels through the filter bank.

Particulate loading covers the carbon before its adsorption capacity is used.A dedicated upstream particle layer protects the distributed carbon surface from coarse dust.

Permohonan yang biasa

Commercial building supply airHospital general ventilationAirport and transport facilitiesLaboratory support-area HVACCleanroom prefiltration with odor control

Parameter teknikal

Representative construction ranges for a combination activated-carbon pocket filter are shown below.

Bahan Teras	Synthetic or glass-fibre particulate medium laminated with bonded activated-carbon media
Ketebalan Panel	360–640 mm pocket depth
Lebar berkesan	287–592 mm nominal header width
Panjang maksimum	Up to 640 mm pocket length
Keluli Menghadapi Ketebalan	0.6–0.9 mm painted or galvanized-steel header frame when specified
Ketumpatan teras	Approximately 80–160 kg/m³ equivalent composite-media density including bonded carbon
Kekonduksian Terma	Approximately 0.040–0.080 W/(m·K) for the dry composite pocket medium
Kemasan permukaan	Painted steel or molded polymer header with dark carbon-loaded pocket media
Jenis Bersatu	Header-frame gasket or clamp-in pocket-filter connection
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Five to ten pocket configurationsSteel or incinerable polymer headerParticulate efficiency selected for the HVAC stageBroad-spectrum or impregnated carbon layer

Planning a Activated Carbon Pocket Filter specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami