STjh 40 mm low-resistance U16 ULPA filter main view

STJH-LOW-RESISTANCE-ULPA-U16-040

Low-Resistance ULPA Filter U16 0.40 in. w.g.

A balanced U16 membrane panel for fabs needing tighter particle control while limiting the pressure increase over U15.

0.40 in. w.g. clean point
U16 efficiency
35 mm ePTFE pack

견적 요청 제품 찾아보기

상품 소개

This low-resistance U16 model targets facilities that need 99.99995% efficiency at MPPS but want to hold nominal clean resistance to 0.40 in. w.g. at 100 fpm. The 35 mm supported ePTFE pack provides a middle ground between the 0.33 U15 and 0.55 U17 versions. System selection should evaluate the actual quantity of panels and loaded operating point, not just the single-filter clean value.

주요 기능

Efficiency-energy balance

U16 lowers penetration by tenfold from U15 while adding a comparatively modest clean resistance at the published velocity.

Stable thin pack

Hot-melt spacing controls the 35 mm mini-pleat geometry for even airflow through the supported membrane.

Retrofit seal choices

Configurable aluminum frames allow the pressure-focused pack to match common dry or fluid-seal ceiling systems.

기술 매개변수

Efficiency Class	U16
Minimum Efficiency	99.99995% at MPPS
Nominal Initial Resistance	0.40 in. w.g.
Resistance Test Velocity	100 fpm net face velocity
Filter Media	Boron-free supported ePTFE
Media Pack Depth	35 mm
Frame Material	Clear anodized aluminum
Media Sealant	Solid polyurethane
Available Seal Systems	Gasket, reverse gel or knife edge
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

Applications

Designed for advanced microelectronics rooms and tool zones where U16 is required across meaningful ceiling area. The modest clean resistance supports energy control, provided the fan and terminal seals are commissioned for the complete array.

Solutions for Your Application

The facility wants U16 performance but cannot absorb the U17 pressure penalty.Select the documented 0.40 in. w.g. U16 tier and verify that its penetration limit satisfies the process requirement.

Filter replacement causes uneven velocities across an otherwise uniform ceiling.Keep frame depth and seal geometry consistent across the zone, then rebalance using measured face velocities after changeout.

사용 가능한 옵션

Specify actual face size, frame depth, gasket or gel side, knife-edge option, guard material and divider or port arrangement.

Planning a Low-Resistance ULPA Filter U16 0.40 in. w.g. specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.