Blue multilayer cleanroom sticky mat shown in complete three-quarter view

클린룸 의류, PPE 및 소모품

Sticky 매트

Multilayer cleanroom sticky mat with peel-away polyethylene sheets, water-based acrylic tack and numbered corner tabs for routine contamination control.

Peel-away adhesive layers for controlled entrances
Captures particles from footwear and cart wheels
Low-profile polyethylene construction with numbered tabs

견적 요청 제품 찾아보기

상품 소개

This Sticky Mat provides a simple floor-level barrier at gowning rooms, airlocks and controlled-area entrances. Each thin polyethylene sheet carries a uniform water-based acrylic adhesive that lifts loose dust from shoe soles, boot covers, casters and cart wheels. When the exposed surface becomes loaded, the operator removes one numbered layer to reveal a fresh tacky sheet without moving the base mat.

주요 기능

Thirty-sheet configurations reduce mat replacement frequency

Numbered corner tabs make remaining-layer checks straightforward

Uniform low-tack surface captures debris without excessive shoe pull

Smooth film supports repeated personnel and light-cart traffic

Floor-side adhesive or an optional frame keeps edges stable in use

응용 프로그램 솔루션

Entrance contamination control must balance particle pickup, safe passage and predictable maintenance. The mat should remain flat, release footwear cleanly and allow a soiled layer to be removed without spreading captured debris.

Excessive tack may pull at boot covers or create an uncomfortable step.Select medium or high tack according to footwear, wheel load and operating procedure.

Weak edge adhesion can allow the mat to curl under cart traffic.Apply the mat to a clean, dry floor or use a compatible rigid mat frame.

Staff may replace the entire mat before all usable layers are consumed.Use clearly numbered peel tabs to identify the active sheet and remaining stock.

Removing a dirty sheet may transfer captured particles to the floor.Peel the loaded layer slowly toward the center and dispose of it immediately in the designated waste stream.

일반적인 응용 프로그램

Used at cleanroom and laboratory entrances, gowning-room transition points, airlocks, packaging areas, electronics assembly zones and cart-transfer routes where footwear and wheel-borne particles must be reduced.

기술 매개변수

The following values describe common peel-off cleanroom sticky-mat constructions. Final dimensions, color, tack grade and packaging can be selected for the entrance layout and traffic pattern.

핵심 재료	Multilayer low-density polyethylene film with water-based acrylic adhesive
패널 두께	1.5-2.0 mm for a typical 30-layer mat
유효 폭	450-900 mm
최대 길이	1500 mm
강철 면면 두께	0 mm, 강철 면재 사용 없음
코어 밀도	910-940 kg/m³ polyethylene film
열전도도 (Thermal Conductivity)	0.33-0.50 W/(m·K), material dependent
표면 마무리	Smooth blue or white peel-away adhesive film with numbered corner tabs
접합 유형	Laminated peel-off sheet stack with floor-side adhesive backing
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Blue, white, clear or grey filmMedium-tack or high-tack surface30-sheet or 60-sheet stacksFull adhesive backing or adhesive stripsNumbered removable corner tabsCompatible rigid or flexible mat frame

Planning a Sticky Mat specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.