Single-sided cleanroom laboratory wall bench with coved backsplash

클린룸 가구 및 스테인레스 스틸 제품

클린룸 실험실 벽 벤치

A single-sided perimeter bench with a coved stainless backsplash and enclosed rear services for clean work along a laboratory wall.

Coved rear backsplash
Enclosed wall-side services
Clear knee and floor space
Modular length configuration

견적 요청 제품 찾아보기

상품 소개

The cleanroom laboratory wall bench provides a continuous stainless work surface for perimeter operations while shielding the wall junction from routine spills and residue. Its coved backsplash rises into a slim sealed service rail with covered power and data points above the rear edge. An open powder-coated support frame preserves operator knee space and allows cleaning beneath the full run. Joined bench modules use aligned worktop seams and removable rear covers so services remain reachable from the room side.

주요 기능

A coved stainless transition removes the sharp internal corner between worktop and backsplash.

A narrow raised rail keeps covered utilities behind equipment rather than within the active work area.

Open C-frame supports leave knee space clear and expose the floor-wall edge for cleaning.

Aligned modular sections extend the bench run without adding enclosed base cabinets.

응용 프로그램 솔루션

Perimeter benches can trap residue at the wall junction and lose usable depth when service boxes are added to the work surface.

A square worktop-to-wall corner retains liquid and cleaning residue.The formed coved backsplash creates a continuous wipe path behind the equipment zone.

Surface-mounted outlet boxes consume work depth and catch containers.Covered connections sit in a narrow raised rear rail beyond the primary work area.

Full base cabinets block access to the floor and wall edge.Open C-frame supports preserve clear knee space and an unobstructed cleaning route.

Long bench runs develop misaligned seams that catch wipes and small components.Registered splice plates align neighbouring worktops and hold a narrow sealed joint.

일반적인 응용 프로그램

Cleanroom perimeter preparationLaboratory instrument supportSample receipt and documentationConsumable stagingNon-hazardous wet-process support

기술 매개변수

Typical configurable specifications for a cleanroom laboratory wall bench are listed below.

핵심 재료	Type 304 stainless steel work surface and coved backsplash on sealed powder-coated steel C-frames
패널 두께	1.2–1.5 mm stainless worktop and backsplash assembly
유효 폭	600-900mm 작업 표면 깊이
최대 길이	3600 mm per continuous bench run
강철 면면 두께	1.2–1.5 mm Type 304 stainless steel work surface
코어 밀도	7900 - 8000 kg / m 3 Type 304 스테인레스 스틸
열전도도 (Thermal Conductivity)	14–16 W/(m·K) Type 304 스테인리스강
표면 마무리	Brushed stainless steel work surface with light-gray or blue-gray cleanroom powder-coated frame
접합 유형	Coved rear upstand with sealed service rail and registered inter-bench splice plates
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Covered power data or utility railUpper wall-mounted shelvesStainless under-bench drawersEquipment cut-outs or raised marine edge

Planning a Cleanroom Laboratory Wall Bench specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.