English
Португальский
Испанский язык
Японский
Индонезийский
Немецкий
Турецкий
Вьетнамский язык
Французский
Русский языкТекущий
Арабский язык
Тайский
Японский язык
Корейский
ОВК и оборудование для обработки воздуха в чистых помещениях
Вертикальная установка по обработке воздуха
A stacked upflow or downflow air handler that reduces plant-room footprint while retaining full filter, coil and fan functionality.
- Small Floor Footprint
- Upflow or Downflow Layout
- Stacked Service Sections
- Rigid Vertical Frame
Введение продукции
The vertical air handling unit stacks treatment components to use room height instead of long floor area. Air may enter low and discharge upward, or follow a downflow path to a raised floor or low duct. Filters, coils and fan sections are separated by accessible service zones, and the frame is reinforced for the vertical component load. Drain and trap geometry are arranged for the selected casing pressure, while lifting points and removable panels support installation in compact plant rooms.
Основные характеристики
Upflow and downflow discharge options align with high-level or underfloor duct systems.
Reinforced base and frame transfer fan, coil and filter loads through the vertical casing.
Dedicated access doors keep filter and wet-section service points reachable from one side.
Решения для вашего приложения
Stacking components saves floor space only if service access, drainage and structural loads are addressed in the vertical arrangement.
A horizontal unit blocks the only service aisle in a small plant room.Vertical stacking shortens the footprint while preserving treatment functions.
The discharge duct must turn sharply and adds unnecessary pressure loss.Upflow or downflow discharge connects directly to the building riser or floor plenum.
Upper filters are difficult to lift and remove safely.Filter stages are positioned at practical service height with slide-out tracks.
Condensate trap height is insufficient under negative casing pressure.The base frame provides clearance for a trap sized to the actual section pressure.
Типичные приложения
Compact cleanroom plant roomsHospital mechanical closetsLaboratory retrofit shaftsVertical supply risersUnderfloor clean-air systems
Технические параметры
Typical casing values for an insulated vertical air handling unit are listed below.
| Основной материал | Polyurethane or mineral-wool insulation in reinforced double-skin panels |
|---|---|
| Толщина панели | 40–60 mm insulated panel |
| эффективная ширина | 800–2400 mm nominal casing width |
| Максимальная длина | Up to 3500 mm horizontal base length for stacked configuration |
| Толщина линий стали | 0.6–1.0 mm casing skins with reinforced base members |
| Плотность ядра | 41–45 kg/m³ polyurethane or 84–100 kg/m³ mineral wool |
| Теплопроводимость | 0.022–0.040 W/(m·K) according to panel core |
| Поверхностная отделка | Powder-coated galvanized exterior with galvanized or stainless inner lining |
| Объединенный тип | Compression-gasketed stacked panels on bolted structural base and vertical frame |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
Upflow, downflow or side dischargeChilled-water, hot-water or DX coilsEC plug fan or fan arrayBottom or side return-air connection
Planning a Vertical Air Handling Unit specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
